the vehicle does not stop !!! (Solved)

When I stopped the car today, I saw that the vehicle's stop system changed completely. Normally yesterday when I stopped the car, I would hold the brake pedal and then I would take my foot off the pedal after I stopped. But today, I switched off the ignition while the pedal was pressed, but the vehicle also stopped, and the abs lamp came on and the stop lamp started flashing, the car stopped when I pulled my foot from the brake. Is this my fault now or something else? ERDİNÇ 2014-03-01 18:15:19

have you ever tried again?

ewet does the same

Blow air into the diagnostic connector jack or clean it a little to the left, check the connections (the boring place where the diagnostic services connect the vehicle to the computer) vice admiral 2014-03-01 17:07:46

I installed the LED on the rear mud, but I connected it to the American parking module. I also took the electricity from the brake lights, so I noticed that both the parks (for the faint burning) and the brake pressure (for the lighted burning) but the module did not stop the car while the parks were open :) :)

[QUOTE = ERDİNÇ] I installed a led fender on the rear fender, but I connected it to the American parking module, I took the electricity from the brake lights, so I noticed that both the parks (for the faint burning) and the brake press (for the lighted burning) but the module was not stopping the vehicle later on: :):) [/ QUOTE] not a malfunction :)

I was afraid that your brain would break down, let your eyes bright

Well, we thought we were big bits :) well, look at your lamp.

Brother Cenker will be angry with me, but I know the most beautiful brake sensor line and do it. The other type of brake sender is going to the BSi network, you are having trouble.

I say too why are my ears ringing :)