Sudden cycle increase and no acceleration

Hello. There is a situation I have been observing lately. 2000 rpm When I watch in 3rd gear, when I get on the throttle, the rpm comes out very fast 3000e, the engine starts to force, but the car accelerates very hard, when it starts to accelerate, the rpm decreases and starts to increase again. Could this be due to pressure pads or timing? My vehicle is over 152 thousand. I haven't made heavy maintenance yet

Yes, in my opinion, it is time for the industry now.

as if the pressed lining alarm.

print pad

My teacher is a high probability pressure pad.

this happened to me too and it improved after 2 days. I think that when washing the engine with diesel, there was fluid contact with the brain cables and it got better. (the master said so)

I contacted our forum sponsor today. They confirmed that the press was lining. Friday I will leave the car in the morning and take it with the good of the evening. I give information again.

Check pads to the nearest industry without being on track ....

Today, I heard about a trial method for printing pads. There were people saying that if the vehicle spreads when it tries to lift the car with the 1st gear while the hand brake is pulled out, it is OK.

Today, the masters of our forum sponsor looked at the car. They said that this was not due to heavy maintenance welded timing or pressure lining, and that the clutch set was OK. They tried other possibilities and decided that they were caused by the injector or injector pump. But today the person who will look at the injector is not available. There is no clear conclusion whether to change or clean.