sound from the right rear wheel

Guys, I recently opened a thread related to torsion, the ball has changed, but I couldn't get the spindle because the lathe is not permitted & nbsp; therefore, the sound was not interrupted. When I enter the lacquer hard with the vehicle, it sounds like a plug, I hear the noise from the small damage on the shaft that I do not understand. Does it have any other reason or experience? FONT>

& nbsp; it sounds so loud, it is heard from here with both red and horseshoe-sized text sound & nbsp;

I would look at the torsion shaft and the back torsion cube .. if it doesn't hold anything too long, if your torsion is not scattered ..

[QUOTE = Long Beach] & nbsp; it sounds so loud, it can be heard from here with both red and horseshoes. [/ QUOTE] is very good or you made me laugh at this time

[QUOTE = brutal] I would look at the torsion shaft and the back torsion cube.

[QUOTE = m1976k] [QUOTE = Long Beach] & nbsp; sounds so much, it can even be heard in red and horseshoes, sound & nbsp; [/ QUOTE] is very good or you made me laugh at this time [/ QUOTE] I love the article 2 in the signature :)

torsion spindle or swab may be a problem in these. I will recommend you to see the problems in the future, but I do not have any problems, I have made the lacquer sound in the smallest tuk, or I do not have to pull the handbrake, leave it light in the middle, you will hear that sound again.

you have opened this topic before. and I told you that there is no torsion you have done, it will recur again. maverick 2011-10-06 01:13:33