|
|
|
|
Lights on the Instrument Panel |
| • Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » Partner | |
| 08.05.2020 20:02 | # 1 |
 CiBaR |
|
|
My vehicle 2003 Model Partner 2.0hdi An incident that happened to me recently confused me. After working for the first 2-3 minutes during the morning, he also started flashing on the instrument panel under the STOP label and the right hand brake warning on the right side. I waited for 1-2 minutes, they did not go out ... I turned off the ignition and started it again. It has not burned any more .... There is absolutely no oil and water reduction, but I wonder if this can cause ... Best regards...  |
|
| 08.05.2020 20:02 | # 2 |
 sonerkyl |
|
|
|
| 08.05.2020 20:02 | # 3 |
 tayfundyg |
|
|
Hello, master, I have the same breakdown, what have you done? What is the problem with this failure? thanks
|
|
| 08.05.2020 20:02 | # 4 |
 Kocak |
|
|
[QUOTE = CiBaR] Good day to all of you ... My vehicle 2003 Model Partner 2.0hdi An incident that happened to me recently confused me. After working for the first 2-3 minutes during the morning, he also started flashing on the instrument panel under the STOP label and the right hand brake warning on the right side. I waited for 1-2 minutes, they did not go out ... I turned off the ignition and started it again. It has not burned any more .... There is absolutely no oil and water reduction, but I wonder if this can cause ... Best regards... [/ QUOTE] If you complete the hydraulic oil, it will end up and stop. |
|
| 08.05.2020 20:02 | # 5 |
 Hudavendigar34 |
|
|
I had a lot of trouble, too. I had the same brake system. While the vehicle was in motion, the hand brake and stop were on and the warning signal was on, the rear drum brake center was scattered, it was draining the fluid from there, we changed the hydraulic, and I did not get the same error again.
|
|
| 08.05.2020 20:02 | # 6 |
| mstfpl |
|
|
There are 206 on the same warning, it gives me the stop text and the light on the right is on.
|
|
| 08.05.2020 20:02 | # 7 |
| bilisimci01 |
|
|
backup water tank level sensor error check the water if the sensor is lime if there is water, remove the air filter front pipe Remove the sensor if you look at the bottom of the spare water tank and remove it if not, take a new one 45 45 TL is not a very expensive piece
|
|
| 08.05.2020 20:02 | # 8 |
| mstfpl |
|
|
thank you thanks
|
|
| 08.05.2020 20:02 | # 9 |
| Karaca3586 |
|
|
lamp burning engine water lamp If the water is normal, the sensor in the water may be defective and perceives it as no water.
|
|
