Peugeot Forums - Peugeot Fan Club

finally i got it ripped

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 301
08.05.2020 14:01 # 1
beddri
If you remember, I had a problem with removing the catalyst without turning on the engine malfunction light.
I wanted to share with you how
Firstly, the floor was dismantled without damaging the sensors and a new piece was cut to keep the pressure called flange tomorrow, corresponding to the upper section of the floor. And I have been using it for a long time and the malfunction light did not go on as far as I can.









and lastly, I did not feel any drowsiness in the lower ages, but the comfort of the car is obvious.





08.05.2020 14:01 # 2
beddri
[img = http: //img131.imageshack.us/img131/3809/03122008785ta2.th.jpg ">
08.05.2020 14:01 # 3
beddri
a small thank you for sharing would not be bad Confused
08.05.2020 14:01 # 4
sinan-s
Thanks for sharing ..
08.05.2020 14:01 # 5
Guests
best wishes. enjoy it
08.05.2020 14:01 # 6
Guests

Let my share be beautiful. but I'll ask anything. How was the obstruction of the katazor? How many km of vehicle was it? How was the fuel condition of the vehicle after the session?

08.05.2020 14:01 # 7
Kaya206
best wishes
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”