Peugeot Forums - Peugeot Fan Club

Cruise Control System And 307

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 307
08.05.2020 14:12 # 1
pug307_26
Friends, I want to install a speed stabilization system on my 2002 model tiptronic vehicle. Is it done with picking up and assembling that lever, and in 2002 model 307 is this system available?
08.05.2020 14:12 # 2
individual
I think I said it.
I'll say it again. No way.
my friend had 2003 model 307.
When I opened the hood, the gas wire appeared near the left headlight.
Drive by wire (electronic accelerator pedal) system must be available for speed stabilization / limiting.
A device that normally produces the throttle's work, the angle of pressing the pedal and the throttle position signal in relation to the angle.
08.05.2020 14:12 # 3
individual
The new generation of 2004 and above.
though I spoke a bit ambitious, but I hope no one will make me liar
Gülme
08.05.2020 14:12 # 4
pug307_26
yes, you said thank you again but there is an alternative not liar insallah
I have the socket for the signal arms CC in my vehicle that day Kahkaha With the lid closed, duuro beautiful beautiful Sırıtma I hope this system will happen in 307s with gas wire Sleepy Is there any friend among us who has 2002 model 307 and cc
08.05.2020 14:12 # 5
H-a-d-i
our member yusuf ziya taslica (yzt06) made this work on his own vehicle. he knows something.
08.05.2020 14:12 # 6
okan77

Due to the model, the electrical system is divided into two as a van can ... I have to try it but I don't think if there is a gas wire ...

08.05.2020 14:12 # 7
individual
[QUOTE = okan77]

Due to the model, the electrical system is divided into two as a van can ... I have to try it but I don't think if there is a gas wire ...

[/ QUOTE]
van bus`s old safe (2001-2005)
can buses new safe (2006 -...)
There are very few vehicles that have 2005 can bus. it's a very exceptional situation. They are called look.
some looklar van, some can. there is a separate subject
If the vehicle is 2002, it is van bus.
my vehicle is 2005 model. I did. works smoothly. (van bus)
There is also something like this.
vehicles are updated from time to time. these updates are renewed at any time deemed necessary, rather than the old case - the new case.
I witnessed with my own eyes.
2003, 2004 and 2005 model 3 separate 1.6 gasoline 307 side by side and open the hood.
The engine design of all three vehicles is different.
of course its power, torque etc ... same. the main parts are the same.
but the auxiliary parts are different and positioned differently.
they have to be updated from time to time as per the emission rules.
In other words, it is wrong to link a vehicle to another vehicle, the old case to the new case.
08.05.2020 14:12 # 8
controller
2006 (new type) 307 gasoline vehicle installed, 175 TL at the authorized service. He attached the handle and opened the cruise control from the computer / introduced it to the system and completed it. It lasted for 10 minutes ... it was very nice ...
08.05.2020 14:12 # 9
H-a-d-i
enjoy it
08.05.2020 14:12 # 10
controller
Thanks dude :)
08.05.2020 14:12 # 11
t@lip
[QUOTE = pug307_26] I want to install a cruise control system for my 2002 model tiptronic vehicle. Is it done with picking up and assembling that lever and in 2002 model 307 does this system exist?
I think it's best to call the authorized service and ask. I was looking for a very similar situation the other day. Although I was on the phone, he listened and answered in a very relevant way. If you arrive from a private message, I can give the phone number of the service I am calling. In this way, you will reach the exact answer.
08.05.2020 14:12 # 12
yzt06
[QUOTE = individual] New generation 2004 and above.
though I spoke a bit ambitious, but I hope no one will make me liar
Gülme
[/ QUOTE]

Gülme unfortunately it is not true:) my car is 2003 and it is running smoothly. It is happening in 2002.
08.05.2020 14:12 # 13
yzt06
[QUOTE = Come on] this work, our member yusuf ziya taslica (yzt06), had it done on his own vehicle. he knows something. [/ QUOTE]


Come on brother remembered Gülme
08.05.2020 14:12 # 14
H-a-d-i
we are not forgetting. we always remember. You also open the gap very much.
08.05.2020 14:12 # 15
yzt06
Brother died in accordance with the circumstances. If not, you know me.
08.05.2020 14:12 # 16
individual
[QUOTE = yzt06] [QUOTE = individual] New generation of 2004 and above.
though I spoke a bit ambitious, but I hope no one will make me liar
Gülme
[/ QUOTE]

Gülme unfortunately it is not true:) my car is 2003 and it is running smoothly. It is happening in 2002.
[/ QUOTE]
There are 2 types of old case bsi.
bsi ball and bsi light
if the horn sounds when you press the lock button on the remote control,
or if your headlights go out when you lock the doors, cruise control will not fit
this bsi top model
bsi light model, the horn does not sound when you lock the doors, 4 lights are lit
You make a selector once and your headlights stay on for 45 seconds.
this is bsi light model. cruise control fits this.
If your vehicle is old type, bsi top, I would like a photo of your vehicle's engine compartment.
especially the part from the battery to the front headlight.
Gülme
08.05.2020 14:12 # 17
coyote26
Either the speed fixer is a very useful thing ... what is the estimated cost for the 2004 model 307?
08.05.2020 14:12 # 18
H-a-d-i
160-170 TL in the authorized service.
08.05.2020 14:12 # 19
t@lip
A service in Ankara gave a price of 175TL. In some sites it is said that only the stabilizer works for 207, the limiter does not work, I think it is useful to investigate this issue.
08.05.2020 14:12 # 20
ask307
my 2005 model 307 1.4 hdi xr model would get stuck in my car. where can i get one in izmir.
Page : / 31
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”