Carbon coating

Guys I saw it on the internet and I like it. I plan to coat carbon on the side slats of the car, do you think it is a job to be done by hand skills? & Nbsp;

I did it, it costed 30 TL to the side laths, front grille, side pillars, trunk opening lever and gas tank cover.

If you do not have a problem in removing and installing the side slats, first of all, I would buy and try cheap products from signers and advertisers. & Nbsp; there is material ... cheap these are not expensive ... & nbsp;

Try your hand ... Probably you will not be satisfied with the cheap coating material after a while because all kinds of throws ... Then there are very good quality carbon materials ... you buy them and clean them again ... I used to deal with my old vehicles :)

[QUOTE = DS002] I did it, it costed 30 TL to the side grille, front trunk, side pillars, trunk release lever and gas tank cover, took my time about 3 hours [/ QUOTE]

Walla side bars have never been removed, I can even say that it is my first car. It seems that it will not hurt my head. I say I will do something manual now. I have to cover the middle panel of the car.

It happens without removing the laths, but it does so quickly ... if you dismantle the laths, when it bends to the inside, it will not be thrown ... there is no harm in trying ... if you don't like it, you can remove the coating, remove the sticky marks with gas, it will be over. It is more enjoyable if you try to do it yourself rather than having it done ... But of course it requires some mastery.

Do you know if we have pulled the laths, or do we disassemble it from inside? :D

You do not need to disassemble the laths. I did it without disassembling it was very nice.

Well thank you in advance

Now I'm going to cover the hood

It's been 3 months since there is still no throwing

I got it covered, I gave it 50 TL, but I got it shiny black. .com / forum_posts.asp? TID = 25769 "rel =" nofollow "> http://forum.peugeotturkey.com/forum_posts.asp?TID=25769

Nobody does it in Izmir for 50 liras. Even if my brother makes it, the material is very tight. Let's see how we will try, I am undecided whether I make it black or gray.

Make it black I saw in a few cars, the red is so bad, the original of the carbon is black.

If I go somewhere rather than black or gray net, it will probably look black.

If you don't waste 1 square meter, of course carbon will even increase.

friends wonder if there is no picture

take a look at the pictures of koycam

Absolutely make it black, teacher ... Look, I tried a little bit for my old car ... Get an idea ... & nbsp;

I think there is no problem, the workmanship photos have come out very clean now, there is something clearer in my eyes. Thank you very much for sharing.