508 rear parking sensor sound problem

Hello friends, I just joined you. The rear parking sensor sound of my 2013 model 508 access vehicle disappeared out of the blue. It shows as the distance on the display. I will be glad if you are.

If there is an original tape recorder and the speakers do not work and sound, the reason is the disconnection. Check the parking aid and sound settings, it's not something to be broken.

I don't know it's a little past, but I had the same problem. I had hit the rear bumper and broke the stop light. This is the same problem I thought was caused by hitting. But fix it later. Just like you said, there was no sound, but it showed on the display. It improved on its own. Perhaps there is a loose contact in a cable.

Hello there. Thanks for the information. There is no setting in the audio and media settings regarding the parking sensor. The sound problem spontaneously resolved a few days ago.

[QUOTE = 508 delisi] I don't know it's a little past, but I had the same problem. I had hit the rear bumper and broke the stop light. This is the same problem I thought was caused by hitting. But fix it later. Just like you said, there was no sound, but it showed on the display. It improved on its own. Perhaps there is a loose contact in a cable. [/ QUOTE] It is really interesting that mine has recovered by itself.

Hello, I am new in the forum, I am new to the forum, there is the same problem in my vehicle, the rear sensors are working, but it does not sound a warning. A number like 2000 TL was requested. Is there anyone who has knowledge on this subject or who has lived and solved it before.

Hello, teacher. Mashallah What is 2000 TL. They recommended it in a foreign forum. While on the bumper side, try cleaning and remove the connector and spray crc electric or equivalent contact cleaner and test again MASTER RESET1- Disconnect Battery Cables (Negative & Positive Cables) If the battery cables do not reach, you can use any electrical wire as an extension.Do not worry, disconnect both wires to power As we remove the source from the loop, it will not spark, touching them, we cut off all remaining power to reset the modules as if using the factory scanner.2- Hold the cables together for 60 seconds, then release 3- Wait 30 minutes 4- Make sure all doors are closed5- Reconnect the Battery Cables6- Lock and unlock the vehicles using the key on the driver's door side (if you have a key without a blade key, lock and unlock it using the keychain buttons) 7- Enter the vehicle and try to start it then test them again