|
|
|
|
407 SW Partikel filter additive to low? |
| • Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 407 | |
| 08.05.2020 18:05 | # 1 |
 Mustafa-almanya |
|
|
|
|
| 08.05.2020 18:05 | # 2 |
 koliva |
|
|
[QUOTE = Mustafa-germany] The vehicle fails at first start as particle filter additive feel too low, but then goes out and the vehicle is normal. I think the liquid of the particulate filter is running low. Is this a problematic thing to fill in? Can it be done out of service? [/ QUOTE] It is necessary to fill and reset the ECU, about 150-200 euro. If it needs to be replaced, it costs 1000 euros. I can even say that you can fill it out yourself, but I think you can get it done by a master. |
|
| 08.05.2020 18:05 | # 3 |
| Mustafa-almanya |
|
|
Thank you for your interest, ecu. Is it being reset with Pp2000?
|
|
| 08.05.2020 18:05 | # 4 |
| koliva |
|
|
[QUOTE = Mustafa-germany] Thanks for your interest, ecu. Is it being reset with Pp2000? [/ QUOTE] Of course it happens with PP2000. |
|
| 08.05.2020 18:05 | # 5 |
| Mustafa-almanya |
|
|
[QUOTE = koliva] [QUOTE = Mustafa-germany] Thanks for your interest, ecu. Is it being reset with Pp2000? [/ QUOTE] Of course it happens with PP2000. [/ QUOTE] Where should I go from the menu with PP2000, I got a little bit yesterday but couldn't find it. respects
|
|
| 08.05.2020 18:05 | # 6 |
| Mustafa-almanya |
|
|
It was also expensive here, I asked for a part today, 3 l eolys liquid and filling hose said 125 €.
|
|
| 08.05.2020 18:05 | # 7 |
| Mustafa-almanya |
|
|
Sagol Onur, I found the subject you said, but it is both difficult to cancel and the filter needs to be pierced. If I do this, I will not go through the next exhaust inspection. I think if I learn how to reset the ECU, I will fill the liquid to a mechanic with a lift.
|
|
| 08.05.2020 18:05 | # 8 |
| koliva |
|
|
[QUOTE = Mustafa-germany] [QUOTE = koliva] [QUOTE = Mustafa-germany] Thanks for your interest, ecu. Is it being reset with Pp2000? [/ QUOTE] Of course it happens with PP2000. [/ QUOTE] Where should I go from the menu with PP2000, I got a little bit yesterday but couldn't find it. respects [/ QUOTE] The steps are as follows: 1. Test by ecu 2. Engine / gearbox 3. Diesel fuel additive control unit 4. Configuration 5. Manual configuration 6. Cleaning or replacement of pef (counter 1) 7. Filling reservior, lighting of the low additive level warning light (counter 2) You will see a counter in steps 7 and 8. You have to reset them. Note that it is a highly toxic substance. |
|