![]() ![]() |
|
![]() |
407 exhaust emission failure |
• Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 407 |
08.05.2020 18:45 | # 1 |
![]() |
|
![]() ![]() ![]() |
08.05.2020 18:45 | # 2 |
![]() |
|
friends have a suggestion or a reliable peugot mechanic in Ankara
|
08.05.2020 18:45 | # 3 |
![]() |
|
connect it to the computer most likely catalytic finished. There are a lot of pejokers in Ankara. If you want an authorized person, take a look at the page.
|
08.05.2020 18:45 | # 4 |
![]() |
|
a few suggestions ideas ... connect your vehicle to the computer in the service, troubleshooting makes your job easier. possible or potential problems can be caused by bad and poor quality fuel catalytic converter can also be a problem There is such a thing as fap fluid, this fluid related to exhaust gas absorption may be finished, especially when the bottom of the vehicle hits the part where this fluid is located. If it were gasoline, I would say, look directly at the injectors, but because it is diesel, the reasons I mentioned above might be the problem.
|
08.05.2020 18:45 | # 5 |
![]() |
|
Yes, if the catalyst is completely clogged, your turbocharger is canceled because the exhaust manifold outlet is not comfortable, so you cannot exceed 3000 rpm.
|
08.05.2020 18:45 | # 6 |
![]() |
|
Yes, after hitting the bottom of the car, it started to fail, exhausting black smoke from the exhaust constantly, the car faints on the hill.
|
08.05.2020 18:45 | # 7 |
![]() |
|
gentleman completely malfunction caused by catalyst or you broke the below lampta sensor or catalyst is the only solution ![]() |
08.05.2020 18:45 | # 8 |
![]() |
|
sa, you will remove the catalyst and go to the services that wash it in a special machine with boiling water and detergent for 600 lira.
|
08.05.2020 18:45 | # 9 |
![]() |
|
In most error codes, the car does not exceed 3000 revolutions. This is a precaution. After stopping and starting the car, it will work normally for about 45 seconds and then the revolver will not let you pass 3000 rpm. Write a catalytic converter to the sister search engine. There are quite cheap brands in the market as a counterpart. Repair vs Dealing. But first you need to go to a workshop and have it checked for any problems with the sensor. If the sensors are intact, then buy a new product. I did so two years ago.
|
08.05.2020 18:45 | # 10 |
![]() |
|
I have the 2009 model 1.6 string. Last year, while the vehicle was still at 30000 km, on the road, the exhaust emission system was malfunctioning and the engine stopped automatically. It was recurring almost every week. Authorized services could not solve this problem. It is so frustrating that I even thought about trading it, but I could not cut it into the car. Again one day, while going on the road in the evening, the high oil pressure on the screen gave the warning to stop the engine immediately, the screen turned red and then the exhaust emission system defective ASR / ESP system defective writings came after it, of course, the engine stopped by itself. I was disgraced, I was very angry on the road. I even came to smash the car. What does it mean when the engine stops while cruising? This time I took the car to the industry the next day, I just explained the problem I found the master looking at the electrical and electronic systems of Peugeot and citroen brand vehicles. He said that the car has tied to the computer and looked at it and the fuse box inside the engine should be changed. I brought the piece by cargo and changed it. Thank goodness the malfunction has improved. I now enjoy my car. If the vehicle has started to crap on its own, know that the 90% of the fuse box inside the engine is faulty, replace this part.
|
08.05.2020 18:45 | # 11 |
![]() |
|
hello definitely problem with suction monifold. idling sensor, butterfly, monifold will be smoothed out. |
08.05.2020 18:45 | # 12 |
![]() |
|
Hello brother, did you solve this problem?
|
08.05.2020 18:45 | # 13 |
![]() |
|
hello same malfunctions I started too, do devices measure that the fault is from that part like crazy
|
08.05.2020 18:45 | # 14 |
![]() |
|
[QUOTE = mcddag] hello same malfunctions have begun me too as well as does the device measure that the malfunction is from that part like crazy [/ QUOTE] most likely, my teacher will find a good electronics problem. Of course, a good master will not say that there is no important person. If you want, you can diagnose the authorized service so that you do not unnecessarily love the craftsmen. It is between 100-150 TL.
|
08.05.2020 18:45 | # 15 |
![]() |
|
The subject is a little outdated but let me write for general information. Exhaust emission error is a very general error and does not necessarily mean that there is an error in the exhaust system. For example, if there is a problem in one of your valves or if the ignition coil is broken, the unburned gasoline will go to the exhaust and it gives the same failure. Even a problem with air suction can give that error. I generally build my vehicle masters, but if you are not very knowledgeable about car maintenance, at least you should go to an authorized service with special devices for your vehicle for troubleshooting . Let me give you a similar example. The transmission of my car started to fail very much and it was very difficult on steep slopes. I showed it to 4 masters, one of them famous. all said the gearbox should be dismantled. The lowest estimated five thousand pounds, the highest estimate in Turkey came as the largest dedicated service to 13 thousand pounds. but no one could convince me because technically I couldn't accept the event. And the incident came about by chance only in a valve. even that famous master tool made me stand because I did not believe it or hand it over. Imagine if I believed him and handed over the car, an average of 7-8 thousand lira would go and my car would not improve. so it is wise to go to the authorized service for the detection of malfunctions that are not completely sure.
|
08.05.2020 18:45 | # 16 |
![]() |
|
Congratulations, bad masters say they make the car owner a master! Like that!
|