407 DOES NOT TAKE - 407 - Peugeot Forum

I request help from experienced friends with knowledge of friends.

When I give gas to my 407 vehicles, the tachometer goes up to 5000 rpm. Turbo new, turbo solenoid valve (new to solenoid valve), sensors new, no leaks in pipes, maf sensor cleaned, injectors new in maintenance, egr canceled.

My problem is: I don't have to do my friends' traction. already had zero on the engine. My car is not accelerating as if there is no turbo. However, the tachometer rises when it continues to press the gas. On the slopes, I make 2 gears and 4 thousand revolutions. The car starts to go super when you press the clutch while leaving the car and release the 4000 circuit. It is as if the turbo starts producing power after 4000 cycles. Believe me, I slept by car.

By God, I was looking for a vehicle born in 1989. It cooled me so much. However, how much I bought it.

Is the vehicle manual? Don't miss the print pads?

I think my teacher seems to be missing pressure

I don't think it's a press pad, guys. Sometimes I clean the throttle, it goes like a jet. I also unplugged the vehicle because it was canceled EGR. plug in the vehicle does not exceed 3000 cycles. When it is removed, there are 5000 circuits but there is a low hammer.

Well, the flow meter changed, my teacher came to me like a flow meter. Have you looked at the malfunction code later.

08.05.2020 20:57	# 1
serdarr4
I request help from experienced friends with knowledge of friends. When I give gas to my 407 vehicles, the tachometer goes up to 5000 rpm. Turbo new, turbo solenoid valve (new to solenoid valve), sensors new, no leaks in pipes, maf sensor cleaned, injectors new in maintenance, egr canceled. My problem is: I don't have to do my friends' traction. already had zero on the engine. My car is not accelerating as if there is no turbo. However, the tachometer rises when it continues to press the gas. On the slopes, I make 2 gears and 4 thousand revolutions. The car starts to go super when you press the clutch while leaving the car and release the 4000 circuit. It is as if the turbo starts producing power after 4000 cycles. Believe me, I slept by car. By God, I was looking for a vehicle born in 1989. It cooled me so much. However, how much I bought it.

08.05.2020 20:57	# 2
boruc
Is the vehicle manual? Don't miss the print pads?

08.05.2020 20:57	# 3
sonerkyl
I think my teacher seems to be missing pressure

08.05.2020 20:57	# 5
sonerkyl
Well, the flow meter changed, my teacher came to me like a flow meter. Have you looked at the malfunction code later.

	407 DOES NOT TAKE
• Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 407