|
|
|
|
308 170 km overnight |
| • Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 308 (2008-2013) | |
| 08.05.2020 20:09 | # 1 |
 alitnrsvn |
|
|
|
|
| 08.05.2020 20:09 | # 2 |
| alitnrsvn |
|
|
My Peu 308 1.6 vti 120 hp car
|
|
| 08.05.2020 20:09 | # 3 |
 sonerkyl |
|
|
First of all, welcome to us, we wish you to use your vehicle without accident and good luck. Do you have lpg in the vehicle, my teacher, my first question is secondly, how many revolutions do you change? It will be enough to change it in the range of 2500-2700. When was the vehicle last serviced? The problem of not having gas in vti 120 hp vehicle should not be any problem in a city with straight roads like heleki konya.
|
|
| 08.05.2020 20:09 | # 4 |
| alitnrsvn |
|
|
I was honest, thank you, teacher.
|
|
| 08.05.2020 20:09 | # 5 |
| alitnrsvn |
|
|
I have done a few trials with the vehicle. Actually, the problem is that I do not accelerate again when I turn the speed below 3 in 5 gears, or there is a very slow speed increase, and it does not exceed 170 km.
|
|
| 08.05.2020 20:09 | # 6 |
 ggitaristt |
|
|
I noticed while following the instant fuel, my diesel vehicle, but you will have the same .. Up to 170 km speed, the vehicle burns very fast and normal (16-12 lt). As for the 170e, the fuel drops to 8.0lt / 100km. It doesn't mean anything even to root the gas after this speed. Even after 170 and 190 210, when I climb to these speeds, the fuel is fixed at 8.0 lt. In short, there is a limiter in cars. There is a necessity to remove but I did not need to investigate. |
|
| 08.05.2020 20:09 | # 7 |
| alitnrsvn |
|
|
Thank you for your interest in the catalytic convector.
|
|
| 08.05.2020 20:09 | # 8 |
 Peugeot35 |
|
|
My teacher, I would not recommend you to upgrade gears under 3000 cycles. You need to find 3000 revolutions for you to upgrade your gears because the speed drops to around 2500 during shifting. acceleration gear is 4th gear You can force 4 revolutions as far as you can and you can catch 5 km on the indicator. If the pointer does not show end, this is the situation related to the performance of your vehicle. Failure of the vehicle to accelerate adequately; Printing pad is one of the biggest factors of this. If it's over, your vehicle will shout and you can't speed. The spark plugs should be good, if they are half or exhausted, they may not burn the gasoline completely because they cannot ignite enough. |
|
| 08.05.2020 20:09 | # 9 |
| sonerkyl |
|
|
[QUOTE = alitnrsvn] Thank you for your interest in the catalytic convector [/ QUOTE] I'm sorry, I'm not very active at the weekend, I would say that you already have a coil - spark plug - oxygen sensor and a floor check.
|
|
| 08.05.2020 20:09 | # 10 |
| alitnrsvn |
|
|
Eksozcuda repaired vehicle is in good condition |
|