|
|
|
|
307 windshield sprinkler shortage |
| • Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 307 | |
| 08.05.2020 20:18 | # 1 |
 ruhela |
|
|
Since I bought the car, I take it from these fountains every 2 months, the reason is throwing water but not passing the hood, cleaning it, opening it, etc. I do things etc. It becomes unusable after 2 months. Wherever it stays as we plugged in - okay, no more settings. Have you ever adjusted a fountain or solution suitable for our vehicle? otherwise I will go to a solution, in a way that I will buy that of another vehicle and match it. 
|
|
| 08.05.2020 20:18 | # 2 |
 GokhaN |
|
|
I last adjusted when 106 was available but have you ever tried to set it with a pin?
|
|
| 08.05.2020 20:18 | # 3 |
| ruhela |
|
|
No, teacher, this has no place to adjust. Unfortunately, I broke it because there was an adjustment place in the first fountains. |
|
| 08.05.2020 20:18 | # 4 |
 prdxy |
|
|
I can't pass the left hood, but sometimes I do. Does it improve when you change the part you said? Could there be a mess in your water tank?
|
|
| 08.05.2020 20:18 | # 5 |
 ggitaristt |
|
|
Check the water tank and hoses, I think it may be lime covered. This plastic is simple, there is nothing to fail. If you are using tap water, it is normal to block the lime. I cleaned it 3 years ago. Then I always used glass water mixed with water. No problem for 3 years .. |
|
| 08.05.2020 20:18 | # 6 |
 Peugeot35 |
|
|
The engine in the water tank may have a problem. If the saddle has difficulty in turning, it cannot convey the water to the fixing pressures. or the hoses are clogged.
remove the fixings, the nails on the side are breaking, i think you don't deal with fixings |
|
| 08.05.2020 20:18 | # 7 |
| ruhela |
|
|
[QUOTE = prdxy] Me can't pass the left hood, but sometimes I do. Does it improve when you change the part you said? Could there be a mess in your water tank? [/ QUOTE] When I change the part, it gets better and returns to normal. [QUOTE = ggitaristt] Check the water tank and hoses, I think it may be lime covered. This plastic is simple, there is nothing to spoil. If you are using tap water, it is normal to block the lime. I cleaned it 3 years ago. Then I always used glass water mixed with water. No problem for 3 years .. [/ QUOTE] Well, when I remove the sprinklers, I can't stop the water coming from the hoses with my finger. The pump works so well. [QUOTE = Peugeot35] There may be a problem with the engine in the water tank. or the hoses are clogged. [/ QUOTE] remove the fixings, the nails on the side are breaking, i think you don't deal with fixings I wrote in my upper message, teacher, there is no calcification, etc. in the pipes, breakdown pipes.
|
|
| 08.05.2020 20:18 | # 8 |
 KILIC |
|
|
the tank may have been calcified. If it throws in little lime, it may be blocking the sprinkler.
|
|
| 08.05.2020 20:18 | # 9 |
 maximusti |
|
|
my company car c-elysee also had this problem. I pulled out both jets, I held a compressor air to the hoses and the nozzles, it has improved in this way for now.
|
|
| 08.05.2020 20:18 | # 10 |
 K@RUB |
|
|
[QUOTE = ruhela] Hello guys, Since I bought the car, I take it from these fountains every 2 months, the reason is throwing water but not passing the hood, cleaning it, opening it, etc. I do things etc. It becomes unusable after 2 months. Wherever it stays as we plugged in - okay, no more settings. Have you ever adjusted a fountain or solution suitable for our vehicle? otherwise I will go to a solution, in a way that I will buy that of another vehicle and match it. [/ QUOTE] Greetings, Do you use glass water with antifreeze? removes deposits inside
|
|
| 08.05.2020 20:18 | # 11 |
| ruhela |
|
|
Thank you so much for your comments, Before I went to the examination last week, I kept air in the sprinklers, I use antifreeze glass water continuously, when I remove the sprinklers with my hand and when I run it there is an incredible pressure. ?
|
|
