307 stops on the way

Hello friends, I have a 2004 307 1.4 HDi vehicle, I have not encountered any major problems so far, but while I was in the city for three days, the engine light suddenly flashes and the vehicle stops, I start the vehicle again. The engine light is still on. Interestingly, when I start the vehicle again after a couple of hours, the engine light goes out. which happens in the evening, I can't take it to the industry, the next day the lamp goes out, I take it to the master, there is no problem.

Connect it to the computer, does it give an error code

Hello, thank you for your attention, there is the problem, this error happens to me in the evenings, it repeats every three days, the engine fault light goes out after a couple of hours, my master connected it to the computer, there is no problem, the master said that the vehicle will stay for a week and all the wiring will be checked. You know, I wrote to the forum so that if anyone knows or has experienced the same problem, it will help.

Yes, it happened to me too. 1.4 HDI

Just be careful, don't take all the plumbing out, it takes the world's money, look at the cables on the back of the engine, collect if there are messy cables, my car came out in 1 day. What happened in 1 week? I think you should take it to another auto electrician. Tell me my story, maybe it's happened to them too, but don't leave it like that for a week. They ask for a lot of money.

Sir, thank you for your interest, I replied a little late, I'm sorry, I couldn't write because of the certain disaster, I was in Ankara, we reviewed the issues you said, but there was no problem with my master, but the last clutch sensor failed, I changed the part, the problem was a day passed, the same problem started to happen again, think about it, you are on the road, your speed is 80- 90 vehicle suddenly stops, I had a lot of difficulty today I visited a few masters, the pump was checked, the injectors were checked, they said there is no physical problem, when they looked in detail, the car gave a p0200 failure, most likely the room is related to the installation or ecu that goes to the injectors, I left it to the master, I am waiting for the news, thank you again, if there is any improvement in your interest, you i will report back

Hello. I've had a similar problem. It was connected to the device, it was stopping due to the rail sender. After we changed the customer, I did not have a stopping problem.