307 Rear Stop

Friends, how can I dismantle the place I showed in this picture? I have removed two screws under it, but I could not disassemble it, if I think it has teeth, I do not want to break the result of wrong intervention :)

After removing 2 screws from the bottom, you have to press the balance backwards one way

I'll take it a little hard. Most of the time it gets dirty while removing it. You have to push the whole unit out by pushing on the screws.

I think that the plastic parts stay in the sun for a while, at least soften, then try not to separate the plastic parts with a screwdriver, just press it from the rear screws.

I was thinking of wearing a led too so that there would be 10 more reds on it: / Thank you all for the information.

Be careful when removing it, I did not know when removing it first, I tried to remove it from the edge with a screwdriver, I cracked it very little from the edge, then I glued it smoothly & nbsp; :)

[QUOTE = kiracoglu] Be careful when removing it, I did not know when removing it first, I tried to remove it with a screwdriver from the edge, I cracked it very little from the edge, then I pasted it smoothly. come on .... [/ QUOTE]