307 rear bumper socket

friends, the storage section of my vehicle is filled with water, and if I ask that this bumper comes from a section where the cables go, can someone show me the picture of the bumper socket or clip or screw places with pictures, I will throw fish in the car or look at the schemes like a full aquarium and I do not understand anything, thank you!

that plasticine siliconed it over the weekend but did not cut the water falling into the bumper.

Are you sure you're getting water from there, but?

A scheme like this maybe works for you:

water comes from section 78 of this diagram

Removal - installation: Rear bumper 1. Removal Remove: Rear lights (/). FIGURE: c4bf30ed on both sides: Disconnect the rear part of the hood. Remove the connections (1 - 2). Remove the clip (3). FIGURE: c4bf30fd. Remove the lower link (4). FIGURE: c4bf30gd on both sides: Remove the bumper from its points (A - B - C). Disconnect the license plate lamps. Remove the rear bumper. 2. Installation Install the bumper from each corner. Continue fitting in accordance with the opposite order of removal. Check electrical operation. hallowman20052011-12-29 14:19:09

Removal – alias: Rear bumper strip

hallowman2005 2011-12-29 14:21:29

If the schemes I sent are not enough, I can upload the schemes of the vehicle directly if you send the chassis number of the vehicle privately. Good luck with.

Friends, this morning I realized that there was a semi-olympic swimming pool in my trunk: S napcaz yahu :(

hallowmen2005 thank you very much I am on duty at the market, I should try :)

There is a point not mentioned in the splendid scheme. & nbsp; When you open the tailgate, the plastic part remaining inside is riveted.

friends, I think this is not the job with the paste and silicon. There is something else in this business. I think there is a rotting of gasket or something.

+ güpgüncel

I tried to sting today, but it never seemed to be in my hand, but I did not handle it, but the place where the water came from is definite and definite dim memory :)

Where did he come from?

friends, as a result of a long shame, I had a meal break with my friend today, but we haven't had time to fix the problem.

I will disassemble and open an exhaust place at the back, and it will not be bad if there is an exhaust right and left.

[QUOTE = gorkemteke] friends, after a long shame, I had a meal break with my friend today, but we haven't had enough time to fix the problem. > I'm waiting curiously.

friends first we insert the satopes, then you will insert the nuts and the hot ends you see in the first picture under the stops




then there is a screw at the top of the tires under the hood, which I have indicated with an arrow, you insert it



I have 4 locks and one screw that I forgot to take pictures of. At the bottom right and left corner, each one connects the bumper with the bumper and the other screw connects the bumper to the vehicle under the bumper. When you lie down, the main thing that draws your attention is now the sections that take water. I turned around with silicone plate lighting cables came to the point where I came back with black silicone. = "_ blank" rel = "nofollow">





NOTE I HAVE MADE THIS OPERATION AT 11 NIGHTS AT LIGHT NIGHT :)