Peugeot Forums - Peugeot Fan Club

307 joystick

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 307
08.05.2020 21:25 # 1
Ferhat5834
Hello to everyone. I bought a android tape on my Peugeot 307 vehicle, it is working properly, but there are 2 control cables in the tape key 1 key 2. My question is, which cables are from the radio control of the vehicle, where should I connect these key 1 key 2 cables, thanks to everyone in advance
08.05.2020 21:25 # 2
Ferhat5834
I think they have no knowledge, but thank you everyone, I took care of the problem. Maybe I can write something here because it will benefit someone. The remote does not fit the bikes alone. I found a solution like this, I removed the control and found the volume up part pins by trying one by one. I soldered three cables, one of the pins, one of the pins, one of the pins, one of the sounds, one of the sounds, and of the volume, and I carried these cables to the tape. I connected the common end to the chassis, that is, to any bios with a negative pole, and I connected the other two cables to key 1 key 2 one by one. There are control key definition in the tape settings, I have defined the volume up and down keys there. But the only problem was that I could only turn up the volume and turn it down when I wanted it

08.05.2020 21:25 # 3
omerb
hello hello. Sometimes we are unable to log into the forum, as we know.
There are circuits for the control. When you connect it, you use all the steering control features. The tape should be compatible.
Volume keys, back and forth keys, ball, mute, sec key are all working.
08.05.2020 21:25 # 4
Ferhat5834
already, my keys are a little broken in the fabric, I actually did this work for the experience.

08.05.2020 21:25 # 5
sonerkyl
You can do it, I need to get out the circuit diagrams and do preliminary work on a paper.
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”