307 HDI Engine Identification, Data and Tightening Torques

B1BB1BK1 - 307 DV4TD ENGINE IDENTIFICATION, DATA, TIGHTENING TORQUE (S) ENGINE 1 - IDENTIFICATION (1) Scope of identification marking: (A) type identifier (B) element reference mark (C) Production sequence number 2 - DATA pressure molded liners and pressure aluminum alloy cylinder blocks cast under. Crankshaft bearing cap sump fixed with 10 screws from each corner of the bearings. Pinless cap housing main axis bearings and pin cylinder block main axis bearings. Crankshaft and internal counterweights with forged bearings and hubs. Connecting rods made by disassembly with connecting rods fixed with screws. The crankshaft ends are sealed by the cylinder block on the flywheel side and the sealing rings in the oil pump housing on the distribution side. engine type DV4TD engine code 8FZ no special features unit reference book - number of cylinders 4 cylinder diameter x course (mm) 73.7 x 82 capacity (cm3) 1398 compression ratio 18 maximum power: kW: EC 50 maximum power: BG (DIN) 69 motor speed at maximum power (min) 4000 max torque: daNm: EC 16 engine revolutions at maximum tightening torque (min) 2000 turbocharger yes no changer (no) turbocharger pressure: rod (s) 1 supply system Make HDI (*) BOSCH type EDC16 (*) high pressure direct injection 3 - TIGHTENING TORQUE (TIGHTENING MOMENTS) 3 - 1 - TRANSFER ORGANS SUSPENSION reference / explanation danm (1) engine right support connection 6 (2) engine right support connection / spacer ear (3) intermediate ear 5.5 reference / description da.Nm (4) torque reaction rod connecting piece 4 (5) anti-torque flexible wedge link on flexible wedge 5.5 (6) antitork flexible wedge connection 4.5 reference / description dam (7) flexible wedge connection on hood 2 (8) battery compartment 1 (9) flexible wedge connection on the bracket 3 (10) connection of the gearbox on the left flexible wedge 6 (11) shaft connection of the gearbox on the flexible wedge 2 3 - 2 - MOVING CONNECTION main bearings of the crankshaft reference / description daNm special features are not available cap sump connecting screw / cylinder block (pre-tightening) 0.5 cap sump connecting screw / cylinder block (tightening) 1 fixing screw for the sump caps / cylinder block (pre-tightening) 1 fixing screw / cylinder block for the sump caps (loosening ( °)) 180 ° crankcase cap setscrew / cylinder block (tightening) 3 piston rod caps bolts (pre-tightening) 1 piston rod caps bolts (loosening) 180 ° piston rod caps bolts (tightening) 1 piston rod caps bolts (tightening (° )) 100 ° crankshaft pulley fixing (pre-tightening) 3 crankshaft pulley fixing (tightening) 180 ° engine flywheel fixing screw (pre-tightening) 1.5 engine flywheel fixing bit screw (tightening) 75 ° piston bottom choke 2

Aim for the work of Haşim abi, there is no information.

[QUOTE = Honor] Haşim brother labor is not available. Valla 1.4 206 of them, if you share them too, brother [/ QUOTE]