Peugeot Forums - Peugeot Fan Club

307 gas cutting emergency

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 307
08.05.2020 21:25 # 1
Ferhat5834
hello everyone i need urgent help. I have a gas cutting problem in my vehicle. I got on the car, I go, I proceed lightly. This incident exists in every gear, when it hangs on the gas and pulls itself back. Vehicle 2004 petrol lpg 1.6 engine peugeot 307
08.05.2020 21:25 # 2
Ferhat5834
nobody knows? I doubt the maf sensor but I wonder if it could be it
08.05.2020 21:25 # 3
omerb
Hello. There are many reasons for this. It is best to get an error code. It is very difficult to find it without connecting it to the device.
08.05.2020 21:25 # 4
Ferhat5834
I connect to the vehicle with obd but no malfunction code appears
08.05.2020 21:25 # 5
omerb
can you answer the questions below

Did you clear the throat butterfly?
Is your air filter new?
Is there a vehicle stopping problem?
08.05.2020 21:25 # 6
Ferhat5834
I cleaned the throat butterfly 1 month ago but not detailed. My air filter is old, but I cleaned it.
08.05.2020 21:25 # 7
omerb
You cannot clean the filter. The biggest mistake is keeping compressed air in the air filter. There are micron level pores in the filter. When the compressed air holds on to them, these pores grow and they start to get into the throat butterfly, as much dust, etc.. First of all, I suggest you change your filter. It has a profit and no harm.

08.05.2020 21:25 # 8
Ferhat5834
I did not hold air to the filter, it was clean when I removed it, I hit it a few or so, I threw it in the dust. The vehicle will be periodically maintained anyway. Then, if I do this, if I disassemble the air filter hose and take a tour, it will be the same problem. Is there any probability that it is from the maf sensor?
08.05.2020 21:25 # 9
littlenikksay
I will ask a question, when the car is idling, when the bottom makes gas, does it drop dropping in idling.
08.05.2020 21:25 # 10
Ferhat5834
No, it works just fine when it is idle. The trouble is just going on the way
08.05.2020 21:25 # 11
omerb
One of the maf sensor malfunctions is poor performance and slow acceleration.
The malfunction may be caused by this, but it must provide the malfunction code.
08.05.2020 21:25 # 12
Ferhat5834
No malfunction code does not disassemble maf sensor, I cleaned it today
08.05.2020 21:25 # 13
littlenikksay
Have the oxygen sensor's values checked
08.05.2020 21:25 # 14
Ferhat5834
ok let me see
08.05.2020 21:25 # 15
ismailkaya
The first reason of the vehicle's stop problem is the oxygen sensors, the air can not adjust the gas mixture, the vehicle is choking or stopping. 2. Reason of air pressure in the manifold
08.05.2020 21:25 # 16
Ferhat5834
Thanks today I will connect the car to the computer and see what will happen.

08.05.2020 21:25 # 17
Aknkzltpe
Let my 307 vehicle run at idle and sing and help the engine malfunction light flash.
08.05.2020 21:25 # 18
Ferhat5834
could be spark plugs
08.05.2020 21:25 # 19
omerb
[QUOTE = Aknkzltpe] Let my 307 vehicle run at idle and help with information that I did not move the engine malfunction light is flashing [/ QUOTE]

There are many reasons, you must first learn the fault code.
08.05.2020 21:25 # 20
Ferhat5834
Omer brother is right, first of all, the malfunction code should be read
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”