|     | |
|   | 307 control problem | 
| • Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 307 | |
| 08.05.2020 14:07 | # 1 | 
|  higungor | |
|  | |
| 08.05.2020 14:07 | # 2 | 
|  H-a-d-i | |
| 
 Is it the control of the alarm or the control with the original ignition key? 
 | |
| 08.05.2020 14:07 | # 3 | 
|  higungor | |
| 
[QUOTE = h_307]  Is it the remote control of the alarm or the original ignition key?  [/ QUOTE]  | |
| 08.05.2020 14:07 | # 4 | 
|  H-a-d-i | |
| 
 Perhaps there is a problem with the electronic circuit inside the plastic assembly. you can show it to an electronics store.  The new one is introduced in the service and is around 130-150 TL. you will open the tip yourself. | |
| 08.05.2020 14:07 | # 5 | 
|  higungor | |
| 
[QUOTE = h_307]  maybe there is a problem with the electronic circuit inside the plastic assembly. you can show it to an electronics store.  with the introduction of the new one in service, around 130-150 TL. you will open the end yourself. [/ QUOTE] | |
| 08.05.2020 14:07 | # 6 | 
|  H-a-d-i | |
| 
 yaw yours worry too? 3 penny cost. Don't worry. at least he has a cure. 
 | |
| 08.05.2020 14:07 | # 7 | 
|  higungor | |
| 
[QUOTE = h_307]  yaw yours worry? 3 penny cost. Don't worry. at least there is a cure for it. . I already said it as a joke   & nbsp; | |
| 08.05.2020 14:07 | # 8 | 
|  hasimayaz | |
| 
there is a short circuit in the circuit. exploiting battery. clean the card with contact cleaner and heat it with air soldering iron.
 | |
| 08.05.2020 14:07 | # 9 | 
|  higungor | |
| 
Mr. Haşim Bey did what you said there was a leak in the electronics shop and said so. There is current in the board, so the battery is running out quickly. But they said we could not find a solution to go to the service.
 | |