307 CEILING FLOOR CHANGE --- PICTURED ---

The roof trim of my Peugeot 307 could not stand up to the heat.

I started to ask about ceiling tiling prices in Izmir, the third industry said 300tl, even this is a terrible figure for this job. I rolled up his sleeves.

First, I did research how to disassemble, attach, etc.

This is not a work to be done alone, this should definitely help at least 1 person.

You should definitely have a torque wrench. sun visor arm handles etc. all in the ceiling.

Then you start first to remove the sun visors at the front and then to remove the handles on the sides.

then we unscrew the front and rear lamps, which is the easiest thing to do with the screwdriver bit, it turns out immediately and one socket is connected, we just remove it.

The ceiling does not leave itself as it should fit on the door seals. then we get rid of the seals and remove the ceiling.

We removed the fabric from the ceiling. Something like ceiling polyester needs to be kind to friends. I threw away the fabric. Afterwards, we remove the sponge layer between the fabric and the polyester ceiling with the desired wire brush. I removed it by hand and removed it very easily.

Then I went to the upholsterer and bought 2mt fiber fabric with the same color inside.

I gave 60 tl to 2mt and 25 to 1lt adhesive (said the adhesive was 206).

So the total cost I made is only 85 TL !!!

Since there is a pan gun at the workplace, I threw the adhesive with the air gun, so if the possibility is faster and easier. Otherwise, you can also do it with a brush. When applying the adhesive, pay attention to the edges and the parts where there are holes, apply it thoroughly and make sure that it is applied equally to all sides in terms of strength and lack of pot. I applied it nicely and put it in half, so that the adhesive doesn't dry, then I applied it to the other side and put it again. I pressed it from the middle to the edges with my hand and made sure that it adheres well by paying attention to the oval places. I even put as much weight in the office as I was drying, so I put weight on it:)

I cleaned the holes and bolts with the utility knife. be careful, you don't need to cut it right up to the corners. It is enough if you cut enough screws, nails and lighting. and one of the most important points is that I cut the excess edges of the ceiling with scissors, do not cut it to zero.

And finally, the hard part is to replace the ceiling, and the part is doing a little bit, but there is nothing to be afraid of. We put it in 20 minutes with 3 people and we put the sun visor etc. in 15 minutes. peel off the door seals before installing the ceiling.

and the result

I wrote a little long, I hope I could help with detail.

How was my teacher?)

And did you just apply glue to the ceiling or should it be applied to the underside of the cloth?

health to your hands ..

And did you just apply glue to the ceiling or should it be applied to the underside of the cloth?

my advice is definitely buy from where you buy the upholstery fabric, the price is the same or even cheaper. Apply thoroughly with a brush.

You just put it on the polyester part of the ceiling.

Well, teacher, we would go into the flooring business, look at the cost.

I do not have much manual skills. I am an accountant.

search the video fln will grow a little bit nothing