![]() ![]() |
|
![]() |
307 abs fault handbrake on |
• Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 307 |
08.05.2020 19:16 | # 1 |
![]() |
|
|
08.05.2020 19:16 | # 2 |
![]() |
|
teacher, charge your vehicle, the electrician usually has a little bit of "connectors" on the dynamo that regulates this if these errors occur due to excessive charge, if the brain protects itself.
|
08.05.2020 19:16 | # 3 |
![]() |
|
The tachometer had failed in me. Malfunction lamps were also flashing. Although the electrician said normal in the starter dynamo, I persistently changed it due to the information in the forum. No problem left. Parts and labor were made for a total of 100₺ last year ..
|
08.05.2020 19:16 | # 4 |
![]() |
|
Thank you, my teacher is not giving the handbrake on warning for now. But a new problem started kicking while the car is in motion. Then, after going a long way, it is singing again, then it passes. I will go to the industry tomorrow, but I don't know how the starch will work: /
|
08.05.2020 19:16 | # 5 |
![]() |
|
Sir, I don't know if it has anything to do with your problem. But this connector (starter dynamo) is a quality material. Even though it is a malfunction, it takes you for a long time. I bought my car 3.5 years ago. Intermittent malfunction lamps (almost all) burned out. When the connector changed 1 year ago, the vehicle seemed to have just left the factory. Now it unnecessarily burns. Even if there is no solution to your problem, I recommend you to replace it with a good electrician. After all, that piece also has a lifetime.
|
08.05.2020 19:16 | # 6 |
![]() |
|
I know the buddy tool is giving this error because of 2 things. Battery and charger. First of all, if there is a 70 Amp battery, I wish you to install and try it and then if it misfires, I wish you to check the charge dyno again because the charging dynamo will not charge the battery, it will be finished in the new battery and you will get ABS fault when going on the road, then the Airbag OFF / ON error and then suddenly the steering hardening and You will get the error STOP. Since the vehicle is running, it will automatically shoot itself, which will cause the brain to become thoroughly mixed. IS EVERYTHING BY ME! NOT FORECAST!
|
08.05.2020 19:16 | # 7 |
![]() |
|
Except for misfire, 3 months ago, the same symptoms you had were in my car. The Conjector in the charging dyno changed no problem. (I gave the piece 90 TL labor 50 TL.) The important point was the failure occasionally and when I went to the repair shop, the charge voltage was normal if there was no breakdown at that moment. However, one day, while the mechanic was due to another malfunction, the malfunction lights started flashing. In the charge measurement we made at that moment, we saw that the dynamo gave high charge (16.4) volts. We solved the problem. It is better if you give priority to the connector replacement rather than the battery replacement. Because the fault is not caused by low voltage but High voltage.
|