307 1.6 hdi stop when going (solved)

recently, while driving on the road, I shake it as if I pressed the gas for 1.2 seconds, I continue the road after that shaking, after 1 or 2 km, it stops regardless of speed. When using at highway speeds, it does not work with the current speed of the vehicle, and when I pull it to the right, turn the ignition off and on, I can work and continue without any problems. it can be very dangerous on highways and it bothers me a lot. Why does no malfunction light come on ? (I changed the diesel filter and fuel station with the suspicion of diesel, the problem continues) oguzhan53 2019-01-31 18:13:43

I think they have a problem with their injectors or diesel pump.

Replace the crank speed sensor.

[QUOTE = GökhaN] I think they have a problem with their injectors or diesel pump. oguzhan53 2019-01-28 18:29:40

[QUOTE = ersin61] Replace the crankshaft sensor. Connect it to the device, it should appear there. Around 250 TL original ... (no code in normal fault device, let me look at a service with planet 2000) oguzhan53 2019-01-28 18:32:04

I would intermittently interrupt me once, stopping spontaneously. When raising the gears, it was like raising, usually from 2 to 3. -15 min.

[QUOTE = ersin61] He would intermittently interrupt me once, stopping spontaneously once. When raising the gears, he usually raised it from 2 to 3. Do not ignore the change. 10-15 minutes. [/ QUOTE] Ersin, thank you for your interest, I do not ignore your advice since our problems are similar and I will show you to a service with a planetary or lexia program tomorrow, as you say, it is easy to change and the part cost is suitable.

oguzhan bey the same problem happened in me 4 months ago.

[QUOTE = Cem bey] Oğuzhan Bey the same problem happened to me 4 months ago. After looking at the problem with the original pejo software, the crank sensor changed. No problem remained after the change. and the pump scares the possibility, let me look at your peugeot software tomorrow without being on the road, thank you for your answer. oguzhan53 2019-01-28 22:30:31

When connected to PC, P0335 malfunction code was intermittent. The crank speed sensor with 1920EH part code has changed and the problem has been resolved. thank you all for your help oguzhan53 2019-01-31 18:14:48

Good luck point shot ...

[QUOTE = ersin61]

Good luck point shot ...

[/ QUOTE] You shot as you said, thank you