![]() ![]() |
|
![]() |
307 1.6 hdi black smoke |
• Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 307 |
08.05.2020 14:10 | # 1 | ||||||
![]() |
|||||||
|
08.05.2020 14:10 | # 2 |
![]() |
|
Could it be burning oil
|
08.05.2020 14:10 | # 3 |
![]() |
|
My friend, the first reason for this may be the poor quality diesel, he says, if it happens after 2000 cycles, I would say fuel if it does not happen at very high speeds. |
08.05.2020 14:10 | # 4 |
![]() |
|
oil burning car throws white and blue smoke, black smoke will happen in every car, but more means no injector, there is no operation or there is obstruction. there is no problem, but my guess is the fuel you buy may be rural diesel or 10 oil mix diesel oil.
|
08.05.2020 14:10 | # 5 |
![]() |
|
A very high km for carbon clean. not. Complete injector cleaning can be a little costly. For now, you can have carbon clean and try it out.
|
08.05.2020 14:10 | # 6 |
![]() |
|
It has been 2 months since I have used the vehicle, I use diesel diesel from the total.
|
08.05.2020 14:10 | # 7 |
![]() |
|
I think I'll put boron into the engine oil. I wouldn't cut it. No oil burning. I had bora tuna. But it was 120 thousand. |
08.05.2020 14:10 | # 8 |
![]() |
|
Early for 2000 black smoke .. it is normal to start after 2500 - 3000 like this .. I think floor and injector cleaning saves the situation .. Is there a problem in traction ??
|
08.05.2020 14:10 | # 9 |
![]() |
|
the traction is very good on the plain and the series is good.
|
08.05.2020 14:10 | # 10 |
![]() |
|
Antakya bosch is familiar with the owner of the service.
|
08.05.2020 14:10 | # 11 |
![]() |
|
I don't need to add any other additives to the car.
|
08.05.2020 14:10 | # 12 |
![]() |
|
If my brother asked me to do an exhaust measurement, he said that if you ask me, it is not at 60000 km. masters
|
08.05.2020 14:10 | # 13 |
![]() |
|
I looked at the service in km.It is an unpainted, alive vehicle in the car.When loaded on the gas, black smoke starts after 2 thousand cycles, after 1-2 seconds, black smoke leaves its place to white smoke. |
08.05.2020 14:10 | # 14 |
![]() |
|
As you said, the number 10 oil, which is probably cheaper than diesel oil, may have been used, damages the injector. A vehicle at 50000 km throws smoke as if it were at 250000 km.
|
08.05.2020 14:10 | # 15 |
![]() |
|
I would be useful if I pour the injector cleaner with the 20 pounds of diesel fuel when the diesel tank is empty.
|
08.05.2020 14:10 | # 16 |
![]() |
|
I think it is necessary to analyze the situation better. Under normal conditions, a catalytic-removed 1.4 HDI starts to smoke slightly like 2500 and when it reaches 5000 it adds a mess. The smallest injector or turbo shortage is definitely evident on the traction. Experiment with the engine warm during the day to ensure that white smoke is not steamed. I think you should stop by a solid pumper and measure emulsion first. Depending on the situation, the injector nozzles change, catalytic controlled. Injector supply bosch, on the other hand, holds up to 200 - 300 TL of lapping, nozzle change and cleaning. Simens may need to be replaced completely depending on the situation. One should not expect much from the injector cleaner placed in the tank, it will not perform miracles.
|
08.05.2020 14:10 | # 17 |
![]() |
|
In the meantime, you need to change the triger in 80,000 .. After 50.000, it is the best solution for these vehicles to have catalytic problems.
|
08.05.2020 14:10 | # 18 |
![]() |
|
So what happens if a procedural procedure is used?
|
08.05.2020 14:10 | # 19 |
![]() |
|
I didn't understand what catalytic is distressed. How does it harm?
|
08.05.2020 14:10 | # 20 |
![]() |
|
I guess it means the catelithic convector
|