Peugeot Forums - Peugeot Fan Club

306 Spark Plugs Oiling

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 306
08.05.2020 16:19 # 1
B-Devi
My car hadn't been working for a few days. I called the biker today & nbsp; He changed the blades, but the newly installed spark plugs were getting oil in 1-2 minutes. He said that the 3rd and 4th pistons are leaking oil, the engine is dead and zero engine must be made. I am thinking of having it done but I said first let me ask you. Who does this job best and how much?
08.05.2020 16:19 # 2
Ucyuzalti
The top cover will be replaced and the ring will be made. My advice to you is kicking in the vehicle and if there is not much fainting up, you will manage & nbsp; Goodnight.
08.05.2020 16:19 # 3
B-Devi
The vehicle works with whirring. so it doesn't give full efficiency. we didn't try to execute it because it doesn't work properly when not hanging on the gas. Also, when you plug the air filter hole by hand, the engine is comfortable.
08.05.2020 16:19 # 4
Ucyuzalti
This gasoline, LPG demi?


By blocking the air filter, I couldn't understand the relevance of the spark plug lubrication because greased spark plugs can't burn the fuel completely because spark plugs are oiled, and too much oxygen will benefit the spark plug. I think the problem is something else, even if your car has a spark plug.
08.05.2020 16:19 # 5
B-Devi
LPG too. The sound was getting better when I blocked the air filter, but we never tried to move the vehicle. He said that a direct zero engine has to be built, and its cost is about 3000 TL. Also, since the vehicle does not work on gasoline, we cannot control the performance on gasoline. I think the gas automatic is out of order. I never asked him. I don't know how much it will cost.
08.05.2020 16:19 # 6
Ucyuzalti
Is your vehicle carburetor?

If you have a carburetor, if it gets too much air, it will work as if the rolent falls, you stop it when you get up.

A amount loaded at 3000 TL, before you make a good master, investigate the engines of the master. is there any living etc ...
08.05.2020 16:19 # 7
B-Devi
There was only one injection in the car. LPG is not sequential. Will I leave the air filter completely blocked and leave the vehicle on the road? Does lubricating the spark plugs work great? Because my job & nbsp; the car is a very big need "don't
08.05.2020 16:19 # 8
Ucyuzalti
My friend, I drove the spark plugs for 2 years: D is directly related to where the problem is & nbsp;
I think you take it to another master. Even if you have a control of the lpg setting, it is likely that your car is getting more air than I need.
08.05.2020 16:19 # 9
B-Devi
Anyway, when I left the car in the evening, there was no problem. But it didn't work in the morning. Tomorrow, I will clog the filter and take it to a veteran, then :) I hope it will be as you say and I can use the tool B-Devi 2011-10-31 23:17:40
08.05.2020 16:19 # 10
Ucyuzalti
Do not block all of the filter :) Pull the tape to the half of the air where the air comes from. Do not be afraid that car works with duct tape & nbsp;
08.05.2020 16:19 # 11
B-Devi
I pulled the tape the morning of the day before it was broken. He did so until the evening. But when it broke, I removed the filter and looked at it, the tapes I pulled were completely gone. Maybe they melted from the heat because we had a little warmth in the evening of that day :)
08.05.2020 16:19 # 12
Ucyuzalti
You do something administration & nbsp; Take it and try it. Tea demleric calculation without satin zero engine diode & nbsp; "Blink"
08.05.2020 16:19 # 13
B-Devi
:)) exactly. What if it handles me for 1-2 months, I will have zero engines after 2 months.
08.05.2020 16:19 # 14
Guests
Master, you can clog the air inlet of the car with a sponge so that you reduce the air intake of the car and it works more smoothly. If your car is injected, if it is fitted with a normal LPG system, it will install an emulator and it will work with both LPG and LPG. In the meantime, spark plug lubrication problem and not pulling problem can be on the ignition (spark plug) cables of the car and you can change them as well. Good performance.
08.05.2020 16:19 # 15
B-Devi
The cylinders were leaking oil into the spark plug. Isn't the cable out? If I am sure I will change it, but I asked the cables and they said 45 TL. Let's not waste money in this difficult time? :(
08.05.2020 16:19 # 16
Guests
ooooo then you never change the ignition system.I guessed if it could not ignite with gasoline and lubricate it.Then the engine will be built but it will be easier to sell it in this way when selling the engine, and it will be easier to sell it in the future, and the services will know the best place to renew the engine. It is possible to ask and learn about it. You can reach our sponsors and access information from the forum homepage, they show you the most guaranteed and cheapest way. Let it be easy.
08.05.2020 16:19 # 17
B-Devi
Dude, I will give that 3000 TL somehow. I put the engine into rectification. But if I have another problem tomorrow the next day, then I will be demolished :( How safe is this rectified job? Can we find a master who guarantees it? How long does it take for time?
08.05.2020 16:19 # 18
Guests
If you make this work tool separate from you for at least a few days. But if you make it in a nice place, there are places that will make you 100.000km guaranteed, for example in Istanbul and they give you a bill and sign the guarantee. The man who says "I will do it" is not done, because the engine work is not given to every master. So I said the service knows the place that does it best. # 111; ne ">
08.05.2020 16:19 # 19
B-Devi
If any of our forum sponsors are doing this job, of course they will be my first choice. But as far as I can see, there are always particles :(
08.05.2020 16:19 # 20
Guests
Even if they do not do motor renewal, they are very helpful because they are competent. div id = "isChromeWebToolbarDiv" style = "display: n o ne">
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”