![]() ![]() |
|
![]() |
306 socket ball |
• Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 306 |
28.02.2021 20:40 | # 1 |
![]() |
|
The sound goes off when I press the clutch. If anyone has the same problem, how much did you pay for the repair and what are the things we need to pay attention to, I would be glad if you share your experiences about this.
|
01.03.2021 09:33 | # 2 |
![]() |
|
Hello, teacher. If you do not have financial difficulties and the pressure ax has not changed recently, I recommend you to replace it as a set. Again, if only the ball will change, the gearbox will go down, so they only want to work, between 300-500 TL, depending on their master, my average brother.
|
01.03.2021 12:00 | # 3 |
![]() |
|
Thank you, professor, for the information you provided. I've been riding the car for two and a half years
It was about 35 thousand km. I haven't changed the printing lining since I bought it, but I am a little bit economically difficult at the moment. That's why I asked for the repair price. I asked a master in Varosha, he said only to change the ball of the socket between 1000 and 1500 and he was very welcome to me.
|
02.03.2021 07:39 | # 4 |
![]() |
|
The socket pole bearing barely costs 40 50 liras, but a lot of money goes to labor.
It is the disease of our gearboxes. When lowering the gearbox, replace the bearings of the glasses opposite the prism bearing and their bearings if the differential is crowing. Again, with the gearbox lowered, the clutch set and flywheel control, if it saves, the lathe. Be sure to replace the crank seal and axle seals.
|
04.03.2021 01:06 | # 5 |
![]() |
|
Is there any harm in using the bearing in this way?
|
04.03.2021 07:43 | # 6 |
![]() |
|
Now I do not know how much the bearing or bearings are worn. But even the slightest abrasions inside the bearing can make noise. Sometimes the transmission oil that does not change for long periods causes wear on the bearings. This time usually begins. But here we cannot say that the chirping bearings are scattered because the car will not walk if it is dispersed. Or even if it is dispersed at high speed, it may blow up the gearbox sleeve anyway. If it is not done immediately (it should be done), the sound should be followed, it should not be at very high speeds. If the sound is increased, it should be changed without causing higher costs or accidents |