306 Front door trim removal

-To remove the dosememe, you need to insert 3 thick torque screws and the speaker has 3 thin torque screws.

First of all we remove the speaker cover by prying on the edges. Then we insert 3 thin torque screws and remove the socket and take the speaker out.

- When the first of the thick screws opens the door, a plug is left under the mirror. it is seen under the screw when it is removed.

-2nd is under the glass button. the glass button has 1 tab on the bottom and 2 on the bottom. these nails are metal. With a tiny flat screwdriver, you can easily pry out from the bottom. you will see the screw just below. In order to remove the file, you need to insert the glass key from its socket.

-3. In the thick screw there is a small hole under the door handle. You can see the screw when you look upwards from that hole.

After inserting the 3 + 3 = 6 screws, the door will not come when you pull the file. Because it is necessary to remove the plastic frame outside the door opening lever. With a thin flat screwdriver, we pry the edges and remove them in the frame.

-No more heat left to remove plastic nails. If we do not have a nail insertion device, we can remove the upward nails by starting from the bottom with a suitable flat screwdriver or manually. And finally, to save the file from the glass, we lower the bottom of the dosing outwards and lift it upwards. Otherwise, metal parts in the place where thick screws are located are attached and prevent the dosing from coming off.

I want to highlight something else. I would be careful if I inserted the door trim. At the bottom of the dosing, there are two nails next to each other, standing parallel to the ground. but they did not get nailed. There are 2 holes in the full range of these places at the door and it was covered with tape as a fabrication. besides, there is no nail attached there. I bought 1 pack of original nails due to the possibility of breakage before inserting the file. I plugged 2 in that empty place. Before installing the file, the banded holes on the door with the screwdriver can sit on their seats. In this way, when I put the nails on the bottom, I can say that when you close the door, when you close the door, there is a full water sound in the door floor, and the bottom of the file is reduced. Because the part of the file was previously empty. factory did place there but i don't understand why he didn't wear nails beside him

There is an empty nail above the speaker, as I described above. but I did not need to wear it because there is not a very important point here ...