Peugeot Forums - Peugeot Fan Club

306 CAm does not give air.

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 306
08.05.2020 20:43 # 1
umitkc
Hello friends.
The heater is running in my car. But when it is given to the windows, even though it gives a little air by the passenger, there is no air going from the sofor part to the glass. It may be clogged. can i open it with my own possibilities?
08.05.2020 20:43 # 2
sonerkyl
It is not obstructed, as if the steering flaps are broken. If it feels hot when you put it straight ahead
08.05.2020 20:43 # 3
Cyrus35
To get well past, first of all, we need to know the Kliman analog and digital. The malfunction varies according to this situation, because analog, as the soner says, the flaps may have malfunctioned or come out of the socket. There is a motor that opens the flaps in the digitals. This engine or the gear set on it may be defective. In order to check the digital or analog, we can explain where to look and how to look after the solution. There are so many ways to repair and where to look because
08.05.2020 20:43 # 4
umitkc
My vehicle 306 1.6 Grıffe model with an analog clutch .. so Dial ((:
It gives good results to the front but does not give the windows full efficiency.
08.05.2020 20:43 # 5
Cyrus35
all right now :) teacher analog air conditioner control panels have wires and cables behind the buttons just like the bicycle brakes. The end of the wire is connected to the button you turn, the outer protective cable is fixed on the control panel so that when you turn the button, the wire can move back and forth to move the flaps. First of all, the place to look is the control panel. You just need to remove the control panel until you can see the back of it. Check the connection of the cable and the outer cable at the back. It is important that the cable duct outside of it may have been removed, it can also hold a metal nail, it can be displaced like a bow, when it comes out, the stages are halved, as you mentioned. There are 3 separate control wires, you will see that when you disassemble it, it will be enough to correct the abnormal like the others. :) Another option is to lean by the passenger and look at the boiler, you can control the cable connections on the edge of the boiler just like in the control panel when you adjust the level from above to the windows.
08.05.2020 20:43 # 6
umitkc
I will check exactly what you say .. I will write here again according to the situation .. Thank you (:
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”