Peugeot Forums - Peugeot Fan Club

206 XT 2000 Model Manual Transmission Problem

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 206
08.05.2020 17:13 # 1
tersetki
I wrote a gearbox problem in the title, but I'm not sure exactly, so I wanted to share it with you, the problem is that when the car is full throttle at the 3, 4, 5 speeds, the tachometer rises, the engine's noise increases, but the vehicle does not accelerate. I wanted to get your ideas. Why do you think this problem may be caused? & Nbsp;



08.05.2020 17:13 # 2
koliva
Print pad? Test the same situation on a flat surface by pulling the parking brake and trying to get up. If the same situation occurs, that is, the speed is increasing but the car is not working, then the pressure is the lining.
08.05.2020 17:13 # 3
tersetki
I tried, when I try, the car stops. I did not understand 1 couple of weeks ago, the car did not work on gasoline, I took it to the master, the gas pump changed. After that, such a problem arose, but I think it is not from the gas pump. It seemed irrelevant after all.
08.05.2020 17:13 # 4
Serkan
On a steep slope, remove the vehicle up to 5 thousand cycles in 1st gear, then put it in 3rd gear.
08.05.2020 17:13 # 5
sezar206
If there is no such problem before leaving it to the industry, it may not be from printing, but according to the situation described, the pressure seems like a lining.
08.05.2020 17:13 # 6
ozaannn
I definitely had the same 2 weeks ago on the press pad. 1 and 2 don't slide easily either. What is the thought?
08.05.2020 17:13 # 7
tersetki
[QUOTE = Serco05] On a steep slope, remove the vehicle up to 5 thousand circuits in 1st gear, then put it in 3rd gear. [/ QUOTE]

My friend did what you said, the car is screaming, but it is not going ... It will cost much. Thank you very much for all of you.
08.05.2020 17:13 # 8
123456
SLM FRIENDS I WANT TO BUY A 206 1.4 & nbsp; peugeot AUTOMOTIC GEARBOX HOW TO GET AUTOMOTIC GEAR & nbsp; peugeot's suggestions and suggestions.
08.05.2020 17:13 # 9
cinar87
all you need is a valeo brand clutch set;)
08.05.2020 17:13 # 10
tersetki
Yes, all I need is a clutch set of Valeo brand, I made it in Şaşmaz, it held 350 liras, the master has just changed but the sub-industry has been used, now he has no question like a monster. Thank you to everyone.
08.05.2020 17:13 # 11
tellotello
[QUOTE = reverse] Yes, all I need is a valeo brand clutch set. I built it in Şaşmaz, he held 350 liras, the master has just changed, but the supplier industry has been used, now he has no question like a monster. Thank you to everyone. [/ QUOTE]


Get well, use goodbye, my teacher :) 350 price is good but you are sure that you are wearing the original, right? ? It seemed a little cheap to me "Smile".
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”