206 torsion problem

Hello friends
about 6 months ago, the rear axle of my vehicle was completely descended and the torsion balls were changed and turning was done, but the problem recurred and the reason for my car remained unexamined was too much backlash bearing bearing.
I was desperate should I recharge 500 600 and do torsion or should I find out and wear
Is there any place you can recommend in Ankara?
I left my vehicle officially

I think if you find a torsion, I will plug it and it is expensive if you look at zero.

If I can find a clean out, I think about buying it

I think the master or the lathe could not do well, I think that if you want 0 of the turned parts of the work, you can buy them from the back of the lathe.

I have 2 months to exam 2 2 days, I will put it in torsions. Let's see how it will be.

I think you are talking about torsion arms. I think it is also to take torsion arms, but I can not find a master who can do this job.

torsion shafts are sold. and it's pretty cheap. Clean work, let the master take it off until he gives money to the lathe.