206 repair jobs :) Photo + video

Good day, friends, I broke the fan control button, I removed and repaired it on Saturday to install the new buttons, there is no problem right now. It was easy to remove the control wires behind the panel :) but it took me half an hour to install it. Now, I will add the photos that I care for the heater core, while the maintenance was done, I removed the fan relays, I cleaned the oxidized, I put it back, but I will replace it as soon as possible. It was not very difficult to disassemble the heater core, in fact, when the plastic part came off a little bit, I saw that it was at the place where the leaking orings were, even though it was forced, I took the liquid gasket and applied it nicely and collected it again. There is no problem right now, if I had a lot of dripping or something, I would have explained more in detail. good forums for everyone cost 5 tl liquid seal :) sonerkyl2015-08-04 10:05:13

Good work has been well done. Have you ever thought about making the lighting on the panel led

[QUOTE = madblueblacksea] Have a nice work, good health. Have you ever thought about making the lighting on the panel led [/ QUOTE]

Thanks, my teacher, I would like to make a nice presentation one by one in detail, but it was very superficial because I did not have time, it could have been led, but maybe I should bring a new panel from Germany to my brother, maybe I should try it.

http://youtu.be/IDZgAgZq_XQ this is a small video sonerkyl 2015-08-04 10:41:05

Health for your labor Soner teacher has been a very good work :)

thank you emre teacher we did not have a closed space like you :) Let's work cool.

:) If the illegal municipality washes in my place, all the equipment that will stay at the door

[QUOTE = emre41] :) All the equipment that will stay at the door if the illegal municipality washes in my place [/ QUOTE]

[QUOTE = sonerkyl] [QUOTE = madblueblacksea] Good job, good health. Have you ever thought about making the lighting on the panel led [/ QUOTE]

Thanks, my teacher, I would like to make a nice presentation one by one, but it was quite superficial because I did not have time, it could have been led, but maybe I should bring a new panel from Germany to my brother.

Very nice work

[QUOTE = coolhortlak] Very nice work for your labor [/ QUOTE]

sonerkyl 2015-08-06 16:47:29

[QUOTE = sonerkyl] [/ QUOTE]

teacher, it has been a long time but maybe the answer is that i bought a new 206 and there is a crack on the front side of the passenger side that appears in the pictures.

Soner brother. My honeycombs have channels or determine the direction. The plastics out there are making the lactation out back. 206 hdi. Is it easy to just replace it instead of removing it? I wonder where should I dismantle?

Selahattin brother radio information you will unscrew the hat at the top of the screen, then there are two screws on the right and left. . If I have time, I will take a video and upload if you are not in a hurry.

I will wait, brother. it would be perfect. :)

It was well informed that it was a very good work.

We were like hosing the subject, but how did you disassemble the gear section, how did you disassemble it?