206 rear pads replacement

206 rc, gti, cc rear brake pads replacement



Be sure to cut the tires of the vehicle off the ground and secure them firmly.



remove the pin with a wrench-like wrench



Remove the iron part that is used to fix the lining, which I do not know what is in the industrial language, by lightly pulling it out from the wallet with the help of a screwdriver and hammer.



then remove the fat

Let's push the hydraulic piston back by getting support from the caliper body with a strong flat screwdriver. just enough to remove the pads without much effort


After removing the linings, turn the biston clockwise with a screwdriver or a similar tool. This way the piston will enter the inside.



then we place our pads and collect them again


If you want, you can paint Caliper without collecting
and I'm done

i gave it super 30tl just because

If my head is wrong or I change the pad, did I see the painting :) I sprayed the spray without removing the pads.

[QUOTE = Muhammet ÇAKIR] My head is wrong or the change of the pad is also I am painting, I saw it :) I remember spraying it without removing the pads.
you started looking at the end, you will be entitled to the correctness of the title
I have fucked directly on the linings, there is no harm to the paint

Ohoo, I stepped on the back and the pads on the back and paint the paint. there is only a brand visible place on the front pads, I left it empty but it was very nice. Note: Do not tighten the wd40 in case I will remove the dirt rust, brakes may not hold for a while :)

friends, I have 2002 206 1.6 XT 16V OV. BOSCH is recommended as a brand in the linings and brake hoses that will change in the following days. What is your advice?