206 Pulling Back Door Speaker Wiring

Hello.I want to make a speaker connection to the rear doors.

The current article is at the bottom.




samet206 2015-08-07 23:33:20

I am waiting for help if there is information on the cables passing through this socket can be speaker cables for the rear doors, I could not fully understand.

There is a possibility of it. Compare the code numbers printed on the cables that come behind the tape with those at the door.

There are 4 wires in the tape speaker socket, this is only for the front doors, but the number of sockets is 3 on the side, the electrical connector socket of the tape and the connection socket of the front door speakers are not in one of the normal hardware, which means that there is a socket that has no connection to any place completely idle. I do not have a system like this for adding later, or if this idle socket is the steering wheel control arm socket, let me see, compare, measure or something.

If the speaker socket has 4 wires (2 pairs), I don't think there is a speaker cable going to the back doors.

Yes, there are 2 pairs of cables in the speaker socket. Normally it should be 4 pairs. I removed one of the back door antidote. There is no electrical cable going to the speaker socket. There is an empty socket in the tape section outside this socket. I said that the cables inside this back door could be connected. All of the cables that come out belong to the steering control in the socket in the tape section of the central locking system. Even though it seems easy to pull the electrical installation, a troublesome process already destroys the man from the back doors, I know that I always have the installation and coincidence at the same time. I came across the facility, just the tape outputs were not active, I know the line was drawn, I don't understand why.
samet206 2015-08-01 21:33:18

The speaker cable does not go to the rear pendulum. Since the rear speaker is at the door, it passes from the middle pole to the door with a protector.

[QUOTE = Receiving] The speaker cable does not go to the rear pendulum. Since the rear speaker is at the door, it passes from the middle pole to the door with a protector.


[/ QUOTE]

I guess it was misunderstood, I am talking about the door, so I removed the door antidote (trim).

[QUOTE = samet206] [QUOTE = Receiving] The loudspeaker cable does not go to the rear pendulum. Since the rear speaker is at the door, it passes from the middle pole to the door with a protector.


[/ QUOTE]

I guess it was misunderstood, I am talking about the door, so I removed the door antidote (trim).
[/ QUOTE]

if the cable comes out of the tape (i.e. if it is present), the door will reach the mast. there is no way across.

I understand, I will look at it in a detailed time, I hope there are thanks to everyone interested ...

The situation I have received in the detailed review includes the links on the extra socket steering control in the tape section. It has nothing to do with the rear speaker wiring. It was already logically clear, but I said that I could not get a clear answer from the users anywhere but maybe I went over it but unfortunately no rear door loudspeaker harnesses, nor is available in the tape section.

Therefore, there are troublesome points that need to be drawn from the ground to the rear doors, and I would like to consult as usual.

I want to move the cables from one place to the tape section. you say?

Since I did not remove the second glove box, I cannot see and fix the cable until it comes to tape again after the cables come out of the carpet and go to the top of the glove box. It worries me. It is a good place to pass the cable over the torpedo and put it in the tape compartment.

If those who know or are interested in such events help, I would be glad, and I am open in the opinion of anyone who wants to give an idea ...

In addition, the magnets of the speakers in my hand, when I place the speakers very close to the door, there is a mutilation, I do not like this situation between the door and the speaker.
samet206 2015-08-07 23:34:33

I am out of the city and will reply in detail when I freeze on weekdays.

[QUOTE = Recipient] I am out of the city and will reply in detail when I get frozen. [/ QUOTE]

Thank you for your interest. I will take all the ideas into consideration.

If there are friends who have other ideas, I follow the matter. Good evening ...

Hello there,

Now there is a point that I don't understand. Let's be a natural one there.

The sockets on the tape in your vehicle should be as follows.


Here on the left is the socket for the speakers cable. The middle four ten speakers are on the right and the left bottom is the cable of the rear speakers. there must be 8 cables in total. Are there any missing?

If any, the process will be complicated.

After finding the cable for the rear speakers from the back of the tape, write here and I will tell you to the fullest detail. You know, our vehicles were the same, and at the time, I pulled the speaker cable to the back doors. Now I got the gti there is a speaker in the back :) I am in the process of making plumbing right now so the subject caught my attention.

Hello again, the sockets are like this, but there is another socket apart from them. There are 3 sockets in total. The differences are in the electrical connection socket there are no thin yellow and orange wires. There is only 4 pairs of cables in the socket you named as the speaker socket that appears on the left. the indicator that there is no speaker installation, but I was confused by the idle socket head, I thought it might have something to do with the situation, as far as I understand it is the reason why I opened the subject. Socket for steering control.
samet206 2015-08-10 12:53:37

[QUOTE = Samet Çetin] After finding the cable for the rear speakers from the back of the tape, write here and I will tell you to the fullest detail. You know, our vehicles were the same, and at the time, I pulled the speaker cable to the back doors. Now I got the gti there is a speaker in the back :) I am in the process of making plumbing right now so the subject caught my attention. [/ QUOTE]


First of all, GTI is good :) It should be easy for the installation process. It is necessary to take the cable from the door to the tape in my vehicle. It is very useful during these processes. Especially I want to pass the cables under the carpet from the right side and get the tape over the torpedo. It is appropriate for the cables to pass over the torpedo.

Thank you :) It can be a little difficult from the top of the torpedo I pulled the cables from underneath. I tied the cables from the back of the tape, then there are some cables at the bottom. Next to the torpedo, I will pull the cables that I will pull from the bottom inside with a plastic clamp, then I brought it under the carpet and brought it up to the door sill. Unscrew the rovings at the edge of the door, you will already see where the cable will go, hide it there. This is the most troublesome place, you will pass the cables through the socket that you added that photo and then you will insert it into the door. If you do not want to do the same things from the driver's tar, you will pass the left speaker cable for the left door under the rear seats, then pull it from the middle to the mast and do the same. As you know, the back doors are 13cm, but I think it is not worth it if you are going to wear a 13cm normal speaker, it will take me a lot of time if you are going to wear it, or if you are going to expand it to 16 and put 16 speakers, it takes me a lot of time. When you decide to deal with my 05368958306 phone number, send the photos to vatsaptan and I will write what and where to do, and it will be better at the time of application.

What have I written :)

Let your hand see the trouble, thank you master :) You tried to help, if there is a place where I get stuck, then I will bother :)

I disassembled the socket inside the door, I did the cable insertion work.It took a long time to disassemble the socket, the nut-style plastic piece around it was neither playing to the right nor to the left. The back door part is really narrow as a working area. As you said, this is the most troublesome place in my opinion.

As for what I will put on the back doors, I used 2-way pioner 16 cm coax in front of them, the sound is not distorted very clearly, but the tape volume is zero bass between 10-15, bass comes after 20-25. if I catch something in the air, it would be enough. I looked at the situation a little bit again, the pioneer has a 13 cm TSG133CI model, the product is not mdd-bass, there is no screen, etc. But if I have the opportunity to listen to a speaker live sound for bass sounds, my intention is to install something on the back doors ...