206-Outside Rearview Mirror Removal

Did your rearview mirrors fall prey to the white falcon terror .. or did the children of the neighborhood use the goalpost? Do not worry..

When we slightly pull the glass mirror, we can see the position inside. We pull a little harder and separate the mirror from the mechanism. We save the mirror from two iron rods.

That's how iron rods look inside. The nails we need to put up are shown in the picture

We take the nails back to their former position for reassembly

When we remove the mirror, two connectors of heating devices are waiting for us on the vehicle side. We remove the connectors without short circuits. Let's be very careful about what we get from where. even if we have sign paint at hand, let's mark it.

We need to remove 3 Torx10 screws. These screws are the screws of the adjustment equipment. Number 1 on the top.

and screw number 2

and screw number 3.

On the back of the connector, we are waiting for the electrical connector. we remove it with a thin flat screwdriver.

The top cover is attached to the main body with 3 tabs. But we have to do this process very carefully. The cover is very gentle. The same is true in the bottom cover. If we break the nails, we have no return. High attention

The rest of the body holds 4 Torx20 screws. One of the base

other

2 on the bottom

The main body can now be removed.

It's time for the rest of the trunk

If we want to paint the mirror completely or replace the temperature sensor, we must continue with the processes.

We remove the triangular cover on the side by removing it from its nails. High attention to tweeter calories.

We disassemble the connector.

We remove the 3 Torx20 screws. These screws hold the rest of the body

To remove the plastic parts, we need to remove the 2 screws at the bottom and the 2 screws inside.

The process is complete, we can now remove the mirror.

ALINTIDIR. (Turkish translate by Haşim Ayaz hasimayaz@gmail.com ) Make it easy for everyone .