206 modified

When I bought a 206 model xt, I did not have anything on the exhaust tip, I had the lip and glass windbreakers, I do not think of a spring in the car, I am thinking of buying 15 rims as a body kit, I think the rocker and rear bumper attachment, I am waiting for your suggestions, my rear front bumper and door cheetahs black them. Shall I paint it in color?










I think about it as a rim,


monalos 2014-12-13 13:15:12

Should I do the headlight dimming with foil or remove the headlights and paint?

good luck you better put it in the headlights where are you on the slap

Uncle Turhal

Good luck.There are good thoughts, the vehicle is beautiful, good morning. The areas outside it should remain black plastic, but the varnish should be discarded from the top, and the plastic should remain bright. As a top, I think 206+ stops should be used in silver gray color. You need to remove the headlight and apply a dimming to the base with spray paint, but I think the headlights are frosted glass, take a ready-darkened headlight set with a direct transparent glass. The front and front bumpers can be replaced with the bumpers that are slightly sharper and coarser than your original bumpers used in the original RC vs GTI models. If you expand the bumpers, a spring and wide base rubber should definitely be used in this way.

Thank you, I will evaluate your suggestions

I have 206 rear panzolot. I have 4 ovals.

[QUOTE = muro_60] I have 206 rear panzoles, I have 4 ovals.

whatever you give :))

How can we attach a spring to the vehicle? They have a 3.5 fk spring.

You do not understand 3.5 cm spring too much, it is necessary to use 5cm spring when the vehicle is dropped, it is ideal if 5cm spring and 1 tooth torsion are dropped, 1 tooth torsion is pressed about 4cm from behind. I think if you want to press the tool, I would say 5cm spring 1 tooth torsion.

My fog and Pejo emblem do not apply red

Let me give you a hint for the lighting in the silver gray vehicle, not the red fog, but the pink fog.

Dude, you probably changed the light bulb of the parks. It was nice. I wonder what you used ???

I think the vehicle looks very smooth and don't play too much. Make a rim and a spoiler. If you can make fog and headlights, make zenon. Slight dimming. I think the slats look more beautiful. You paint the calipers and drums in red when you wear a rim or a lemon yellow velcro to a green, etc. color. The window film goes away. You can throw black foil on the ceiling. If you do simple and high quality things, it looks very nice.

take out that red on the tank lid, I think it was irrelevant

Do not paint the door moldings, the black parts in the bumper. Shoot the black film 17`` rim. Original candir.

Thanks, I did not like the fog, I took it out, let me try the bidet pink

When I bought the parking lamps, I did not, I thought the original light bulbs, the bidet was in the American park, but the signals were not visible because they did not do the module but with the stone resistor.

It writes gasoline on the tank cap :), some pumpers are wearing diesel) :) but now I get the gas from one place.

Movie and spoiler In my mind, I love it being plain, I think a lot if I throw my car at the wheel. Thanks.

I want to make the Peugeot amp like red, on me and back: /

Go to the tuning seller selling the modified parts, buy a red film, then cover it, I bought 5 pounds, I covered the fog, and the emblems are more. The film will do your job 2-3 pounds.