206 information display light has been lost. Please in. (Vid |
|
• Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 206 |
08.05.2020 20:01 | # 1 |
Eyup B. | |
Could it be insurance? If it is fused, does it give fault light? https://www.youtube.com/watch?v=vqjjqf5yays |
08.05.2020 20:01 | # 2 |
Eyup B. | |
If I think the diagnostic indicator lamp went out, the engine made air, I bought diesel, while coming home .. the only problem now is the error I mentioned in the video.
|
08.05.2020 20:01 | # 3 |
mrtttt53 | |
Brother, I pulled a lot from the single line information screen. A malfunction lamp does not light due to the single line display. But the malfunction lamp will be on a status information screen, for example, my brake hydraulic fluid was exhausted. There is contactlessness in my screen, it is very easy to disassemble, it is very easy to replace the bulbs, but since I cannot solder it, I left it on my own. |
08.05.2020 20:01 | # 4 |
mrtttt53 | |
I have looked at the video now, if you do not have a contactless problem like mine, there are 3 small bulbs on the back of the screen with the bulbs gone. The change is very simple. The first time I disassembled by watching this video, you will understand even if you don't have English. the https://youtu.be/tpyr2ezjsg |
08.05.2020 20:01 | # 5 |
Eyup B. | |
The screen works, the video is obviously just like the house that was cut off from electricity :) By the way, the malfunction light went out probably due to diesel oil, I went for a while, then I parked, I ran it for 1 hour, I tried it for trial purposes. Tomorrow to God :)
|
08.05.2020 20:01 | # 6 |
Gokcesel | |
Have you checked the bulbs? It may have exploded.
|
08.05.2020 20:01 | # 7 |
Eyup B. | |
No I did not. Do I have to remove the panel? i am not experienced before
|
08.05.2020 20:01 | # 8 |
maximusti | |
Which district in Istanbul are you bro? I have obd device, we can scan the error code if you are close.
|
08.05.2020 20:01 | # 9 |
Eyup B. | |
The sultanbeyli. What are we going to depend on? Currently, only the backlight is not on.
|
08.05.2020 20:01 | # 10 |
maximusti | |
You said the malfunction lit up, I said it for him. |
08.05.2020 20:01 | # 11 |
Eyup B. | |
thank you bro the only problem right now is that the screen light is off I hope I will look at it too
|
08.05.2020 20:01 | # 12 |
samet206 | |
I must say, look at the bulbs. If there is a problem such as text faintness or halfway through the text, it is screen film. If there is no light, the bulb is most likely. |
08.05.2020 20:01 | # 13 |
Alicilik | |
Did you use the display rheostas speed? The display and the center display are together. If the indicators are also lit, the bulbs of the display have exploded. |
08.05.2020 20:01 | # 14 |
Eyup B. | |
Light is on in the display. only one line does not light up on the screen. Actually, I threw the phone there with nervousness, so I didn't know it was because of it :) let me just say that again. malfunctioning, single line display in the middle above the tape |
08.05.2020 20:01 | # 15 |
Gokcesel | |
The topic in the forum is about how to disassemble the current screen. At the back of the screen, there are 3 bulbs of t5, replace them and try again. http://forum.peugeotturkey.com/forum_posts.asp?tıd=7976 |