Peugeot Forums - Peugeot Fan Club

206 heating pads

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 206
08.05.2020 19:00 # 1
monalos
Hello friends, there is little water dripping on the heater core, the master radiator did not cut, even though the medicine was thrown, it is possible to disassemble and change the honeycomb without removing the chest. Is it also necessary to change the honeycomb?

08.05.2020 19:00 # 2
serdaralisan
THE CONSOLE IS NOT REMOVED FROM THE REMOVAL BUT IT IS EASY TO REMOVE OR I REMOVE THE MARKET I HAVE RETURNED MY HONEYMOON
08.05.2020 19:00 # 3
fætih
there are those who do without dismantling the console.
08.05.2020 19:00 # 4
monalos
I am not a fan of disassembling the console.
http://forum.peugeotturkey.com/forum_posts.asp?tıd=20250
Changed in 307, if the vehicle is 307, it will be the same as 206 but 206 is narrow in this way 206 or can it be applied
08.05.2020 19:00 # 5
tolga0527
I had the same problem. They said a little bit of kidnapping from the pipe, but he continued to kidnap again. Since the price of honeycomb replacement is too high, I bought a liquid radiator plugs, which said the German brand of 25 TL. Believe there is 1 gram of incontinence I went and bought a red antifreeze for 30 TL. they put antifreeze when the engine is hot, then we put the liquid occluder I bought, we run it for 10 minutes, the performance is very good;) I recommend it.
08.05.2020 19:00 # 6
anafarta44
If you find a master to deal with, the same problem happened with me. my special fault has taken care of Toyota special service
08.05.2020 19:00 # 7
samet206
It is difficult to find a man to do without removing the chest because it has a lot of troubles. Check the gaskets If the problem is not solved, nothing remains after the replacement of the honeycomb. If you wear it in the original part, I use the imported one in the imported part.
08.05.2020 19:00 # 8
fætih
canceled on my radiator.
If I use sub-industry, it would be a problem. It has a price of 45 TL. supplier industry.
08.05.2020 19:00 # 9
monalos
Looked on ebay, the original valeo is 50 TL or more, it makes more sense to take it from there,

I wouldn't dare to change if there was a video or a picture showing the change of 206

They are removing the 307 I gave in the link without removing the chest, I read that subject, man did not do it by looking at the photographs in 206 years, I will do it too, I will change the gasket instead of the gaskets, or we will get honeycomb sub-industry.
08.05.2020 19:00 # 10
ertanakar
In this forum, the removal of the heater core without removing the console is shown with photos .. I found it from here and changed the gaskets ..
08.05.2020 19:00 # 11
serdaralisan
I bought valeo 50 TL, friends from auto Ozturk is not completely removed from the console. In the meantime, there are 2 door poles in the front chest where there are 3 wiper motors, there are screws. Nails and save them, honeycomb is coming out.
08.05.2020 19:00 # 12
fætih
emergency number: D valeo if it is 50 TL, I immediately get: D
08.05.2020 19:00 # 13
monalos
exactly one in me: D
08.05.2020 19:00 # 14
serdaralisan
BEŞEVLER SMALL INDUSTRY OT ÖZTÜRK NEW BUY FRIENDS 50 TL www.otoozturk.com.tr
Address:
Beşevler Küçük Sanayi Parkoop Parçacılar Sitesi 48. Sok. D: 53
Beşevler , Nilüfer , Bursa
Tel: 0224 441 09 07, 0224 443 25 51
08.05.2020 19:00 # 15
monalos
Thanks
08.05.2020 19:00 # 16
ozturksalih38
My friends bought the vehicle 2000 r garros, the person I bought the heater petegino said that he changed the new bill, he gave me the bill, but the car still has a water drop, I still haven't seen the water jug, the sous on the side of the water, but I couldn't see the place where it was missed don't miss it
08.05.2020 19:00 # 17
monalos
I have no knowledge
08.05.2020 19:00 # 18
fætih
[QUOTE = serdaralısan] BEŞEVLER SMALL INDUSTRY OT ÖZTÜRK NEW BUY FRIENDS 50 TL www.otoozturk.com.tr
Address:
Beşevler Küçük Sanayi Parkoop Parçacılar Sitesi 48. Sok. D: 53
Beşevler , Nilüfer , Bursa
Tel: 0224 441 09 07, 0224 443 25 51
[/ QUOTE]
160 tl says?
08.05.2020 19:00 # 19
denizci33
@@ OZTURKSALİH

It means that they couldn't work properly.
08.05.2020 19:00 # 20
ozturksalih38
According to what is written in the form, I will try to do it myself.
There is a bidet heating problem, when the water is full in the vehicle, the temperature is warm even when the temperature indicator is at 90.
Peugeot Forums - Peugeot Fan Club © 2024
“The most auspicious of people, it is people who are useful.”