![]() ![]() |
|
![]() |
206 Gear Shift Lever |
• Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 206 |
08.05.2020 13:58 | # 1 |
![]() |
|
I want to shorten the gearshift lever of my Peugeot 206. When I disassemble the knob, a straight shaft appears, cutting it 1-2 cm will shorten it. But will this have a disadvantage to me? Do anyone have this process before, can you help ltf?
|
08.05.2020 13:58 | # 2 |
![]() |
|
My brother Serhat the old 206 was cut very nice
|
08.05.2020 13:58 | # 3 |
![]() |
|
Apart from a little hardening, there is no side effect that I know.
|
08.05.2020 13:58 | # 4 |
![]() |
|
In my opinion, my way will not be shortened on the roads, but you will get an aesthetic appearance.
|
08.05.2020 13:58 | # 5 |
![]() |
|
I think shortening 2 cm |
08.05.2020 13:58 | # 6 |
![]() |
|
I cut 106 dada, cut 206 dada, no side effects, cut out ...
|
08.05.2020 13:58 | # 7 |
![]() |
|
So how does the cut 306gti cut
|
08.05.2020 13:58 | # 8 |
![]() |
|
[QUOTE = serhat_tutar] I cut 106 dada, cut 206 dada, there is no side effect, cut it off ... [/ QUOTE] So how much did you cut the brother? I think 2 cm ...
|
08.05.2020 13:58 | # 9 |
![]() |
|
Friends who will have armrests like me. don't worry about abbreviation :( |
08.05.2020 13:58 | # 10 |
![]() |
|
[QUOTE = hasimayaz] Friends who will have armrests like me. don't worry about abbreviation :( [/ QUOTE] Yes Haşim, I was thinking of him, there is a armrest in my car. I made a spacer for the new bun, now I'll try it maybe I might not cut it if it looks nice like this |