206 gear problem!

Hello friends, my vehicle has a gear problem for 2 days
The gears are difficult and audible. Sometimes, when it stops completely, the gear does not pass 1e, I pull it 2e again 1e, but it does so, why do you think?

I remember what happened to my gear cubes, my teacher may be from him.

When you say gears, are the ones that go from gear to transmission? Does it have anything to do with transmission oil?

If the oil is lacking, it can also be made from it.

It was abnormal to have Bianda, my teacher, I look at other issues, if I can

It seemed to me not clutch. When I do not enter, I have a little force to see a cart. If you force yourself from the bars, you will check both of them as they will come out. It is possible that it was made of oil, but suddenly you must have blown felt

When it does not enter, it is like concrete. My clutch does not renew. I have a second gear, it is hard in 2 years. Of course, I can throw it to 1.

actual

If the cart is running, the pressure is out of the pad. There is nothing to do anymore. The gear stick does not do much from the gear stick. The gear bars are quickly disintegrated in the middle of the world. if it seems to be too idle with your hand, it means there is a problem in the bun.

No carting, while my teacher is installing like a concrete, I had to force the vehicle to stop without stopping.

How is the clutch's grip point at the bottom?

Clutch flips up, hodja

If it is over, it is over, is it already?

I will change the clutch set next week.

If the 206s are already grasping above, if there is a situation such as adjusting the structure, it is as if it is in the same way. The shifter is damaged due to such difficulties, but 25 TL is something that the piece already replaces it in the change of the press pad, and the master will replace it, I want you to change it. If there is a problem, do not pay for labor again for the gear stick.

Thank you for your answers, friends, I hope it is one of the gearboxes, I will write the developments after the maintenance :)

does not allocate clutches. It will recover when the set changes b. odds. It happened to me as well, if the umbrella of the print broke, how did it break? Although the pressure pad was in good condition, I had to change when the umbrella broke.

I had lubricated the gear rods, the problem seemed to be a little better, he does it every now and again.