|
|
|
|
206 front hood wick |
| • Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 206 | |
| 08.05.2020 21:24 | # 1 |
 kaan206 |
|
|
Is the boot sill and the ten hood seals the same? Can I cut the luggage wick to 50 TL and use it as a hood wick
|
|
| 08.05.2020 21:24 | # 2 |
 GokhaN |
|
|
front bonnet should be harder, luggage should be softer in industry, hose drivers should be in the wick
|
|
| 08.05.2020 21:24 | # 3 |
| kaan206 |
|
|
I couldn't find it on the internet, it is very difficult in industry but I will try my luck None mubu wick tear and replace ??? How did you find a solution? |
|
| 08.05.2020 21:24 | # 4 |
| kaan206 |
|
|
????? Help please there are no modifiers in the forum?
|
|
| 08.05.2020 21:24 | # 5 |
 talip206 |
|
|
Mine was drilled, I glued bally and a tube, I closed the hole :) You can find a similar one even in the places that sell suppositories. You have to find the somewhat harsh one |
|
| 08.05.2020 21:24 | # 6 |
| kaan206 |
|
|
rear boot wick does not read on the hood shape type vs different
|
|
| 08.05.2020 21:24 | # 7 |
 omerb |
|
|
the edge of the wick, which corresponds to the ventilation ducts on the hood, does not press well on the hood. Collapsed. In rainy weather, there is a gap where there are proportional dampers. There is little water filling. It's not a problem, but I still don't like it. I will apply serum hose when the weather is good.
|
|
| 08.05.2020 21:24 | # 8 |
| kaan206 |
|
|
[QUOTE = omerb] the edge of the wick at the place corresponding to the ventilation channels on the bonnet does not press well on the bonnet. Collapsed. In rainy weather, there is a gap where there are proportional dampers. There is little water filling. It's not a problem, but I still don't like it. I will apply serum hose when the weather is good. [/ QUOTE] I searched the original or sub-industry, I could not find it. I will look at the publishers in Istanbul
|
|
