206 automatic transmission problem

Hello Friends, the automatic transmission in the car I use gives an error in snow and sport mode when shifting. The car does not shift into gear even though the rpm increases. It is fixed by turning the car on and off, but it happened to me twice, I heard a thumping sound while driving on the road and the same problem occurred. I went to a mechanic and had it connected to a computer to see the errors in the car, it gives the errors in the picture. What do you think I should do? https://hizliresim.com/ji7q290

I have the same problem. Did you find a solution?

I couldn't find

I bought a device. First it gave a p1327 fault due to dirty fuel. Then it gave a p0700 fault due to transmission. Then it gave a p0745 fault due to pressure. I'm thinking of changing the pressure sensor. It does this when the cables are grounded or dead.

Were you able to solve the problem?

Hello again, friends. I'll be returning my car to İkitelli Sanayi this morning. My mechanic has 35 years of experience at an authorized Peugeot service center. When I told him about the problem, he told me to order enough transmission fluid and two solenoid valves and then return the car to him. I'll get back to you, but I don't know how long it will take to fix the problem. He said that 206s should have their transmission fluid changed after 150,000 km.

I went to a transmission shop through an acquaintance and they connected it to the computer. The gas pedal potentiometer was faulty, so the transmission was switching to protection. He erased the fault with the ORIGINAL software, and the problem is solved for now. I recommend you to have it checked with the original software. It will tell you what the problem is. Most mechanics directly change the valves or say so, and they say that a small fault will cause the transmission to go down. GET WELL BETTER AGAIN.

I have the same problem. It's annoying me. It happens especially in the mornings. It goes away when I turn it on and off. Where did you get it done, sir? Let's stop by if we're in Istanbul. jaseen2024-03-27 18:04:25

Probably the valves and oil will be changed and the problem will be solved, sir. If you can reach the mechanic right now, remind him to reduce the transmission oil meter by the amount of oil he added. Some mechanics just change the valves and oil.

Friends, this problem hasn't been resolved for 15 years. It's a chronic problem. I took the car back from my mechanic today. After two solenoid valves and an oil change, there's no problem. In short, as someone who's tried to fully investigate and resolve the issue, I can say that the problem is with your solenoid valves and the need for an oil change. But it's best not to do it without having it checked.

Hello everyone, I'm having trouble with both snow and sport modes. The car drives smoothly in the city, but after about 30 km of intercity travel in 4th gear, the snow and sport modes flash, and the car shifts to 3rd gear and stays there. Because I've had problems shifting gears before, I've replaced the solenoids, oil, system, and coolant. But this problem has only worsened. Is anyone else experiencing this? Is there a competent mechanic in Bursa? If so, please send me their number and I'll get in touch.

Hello everyone, I took it to the transmission repair shop here in Kocaeli. They changed the celloid and oil. But the error still occurs when I don't connect it to the computer. My car idles naturally when shifting from N to P. The repair shop said it might be because the car is constantly moving. He said the gas problem needs to be fixed, and if the same problem occurs again, the transmission needs to be reconditioned. I took it to another repair shop, and he checked it for a bit. He said it was either a gas leak or an electrical problem, not a computer problem, and that I needed to see an electrician to fix this problem. I'll have the electrician check it after the holiday. I'm driving the car without much effort now.

Hello, where did you go in İkitelli? I have the same problems and more in my vehicle.

My problem is solved. The problem was in the oxygen sensor. The mechanic changed the sensor and the problem was fixed. If possible, have the oxygen sensor checked first. But before this procedure, I had the oil and celloid changed by chance, but it did not fix it.

I have the same problem. The same errors are occurring. There are no errors related to the oxygen sensor on the computer. Is the problem completely gone?

MMYILMAZ2024-11-20 20:01:05