|
|
|
|
206 antifreeze leak is a strange situation |
| • Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 206 | |
| 08.05.2020 20:55 | # 1 |
 ertugerol26 |
|
|
When I checked the anti-freeze tank while doing routine checks on my vehicle, I saw that the water did not remain and I added that after I started the car, I saw that it had risen very little with the water I added, but where did this antifreeze go 4 months ago, there was no wetness under the driver's seat, there was no wetness under the driver's seat. There is no white smoke throwing event, I put a cardboard in the garage, I wonder if there is any dripping wetness, the only point I do not understand is that this is antifreeze water.
|
|
| 08.05.2020 20:55 | # 2 |
 Kysr038 |
|
|
If the water tank cap is not tight, is there any chance it will evaporate and escape over time? I'm guessing this
|
|
| 08.05.2020 20:55 | # 3 |
 sonerkyl |
|
|
There is a possibility of having a water tank cover, as our friend said, it would be better to replace it with a new one. If the vehicle has LPG, have the LPG installation checked. When the engine is hot, the engine escapes when it is hot, does not seem to leak since the pressure drops when it cools down. The worst case is that you can escape the cylinder head gasket.
|
|
| 08.05.2020 20:55 | # 4 |
| ertugerol26 |
|
|
I changed the cover of the teacher, the vehicle is gasoline, but let me check the tightness again. Is there anything possible
|
|
| 08.05.2020 20:55 | # 5 |
| sonerkyl |
|
|
If the cap gasket is new, check the water pipes to the lpg regulator, my brother put t piece there, usually replace it with iron t if it is plastic, if the water pipe clamps are too tight, they may miss them at the weld.
|
|
| 08.05.2020 20:55 | # 6 |
| telepati1903 |
|
|
If there is a water leak, check when the car is cold. The place you should look is the thermostad box..the place where the thermostas box is combined with the body. |
|
| 08.05.2020 20:55 | # 7 |
| ertugerol26 |
|
|
I understand, teacher, I'm on leave tomorrow I will check in detail thanks
|
|
| 08.05.2020 20:55 | # 8 |
| ertugerol26 |
|
|
Thank you for the information you provided. A few industrial friends, who were in the thermostat slab, said the cylinder head gasket. They gave a price between 1000-2000 TL. After visiting a few more places, the master's attention also appeared to come from the thermostat slab. 40 tl zero antifreeze 70 tl labor was taken problem solved
|
|