206 2nd gear final cycle

Friends may sound funny, but I want to ask a question, I pressed until my car dropped to the breaker on 2nd gear to check the 90 horsepower 1.6 engine thrust pad.

My 1.4 75 hp 206 car goes into the breaker at 98 in 2nd gear. plus the car has 17 rc wheels.

bnm 1.4 8v 2.vıtes de cutter, I think 90 goruyo till I see 93kmh like

I have 15 rims, I can't see 98 = (What is the secret of this?

Understood, the pad was a must, so how do we understand the pressure, guys?

[QUOTE = 41as206] there are 15 rims on me 98 do not see it = (what's the secret of this [/ QUOTE] Your car sedan is an extra load, my car is all. the difference may be here.

Depends on the slope of the road, friends 80 I think is normal.

full comprehension, but last episode hyundain is the master for scraping or missing

The city I live in is flat, I think it is not normal for the 1.6 engine to make 80 if I make 98 with the 1.4 engine, of course, if the friend asking is taking this measurement on a straight road.

engine additional parts open h.filters exhaust vs no button

flatness will appear to you, but there is a slight slope. I have 1.4, but it has the same engine and couldn't be passed, but I couldn't do 98. The car also has an open air filter?

[QUOTE = 41as206] engine additional parts open h.filter exhaust vs no button [/ QUOTE] If you are asking me, there is nothing in my car other than the 17 'rc rim and 5 cm stickness.

in fact, there is a barrier to tire size, the strength of the wind, the road slope, the weight, the air suction rate, etc.

friends made the detection on the straight highway, so there was no slope to be noticed. Turgay_66 2014-01-31 18:51:19

Hagi does not depend on how many kms of speed the vehicle is in 1.4 or 1.6, it is completely related to gear gear ratios, that is, it is not strange that 1.6 is 80 while doing 1.4 90, the gear ratios may be different, GTI, for example, 2.0 engine but it does 90-95 in 2nd gear. Try to lift the vehicle in gear and leave it in a steep slope, let's see whether the vehicle will stop or miss without applying the handbrake.

I tried step-down car?

what are you talking about when you say fall to the cutter?

Have you installed a cutter? Normally there is a way until it enters the redline, so if the cutter is not installed ..

Sir, I know it may be wrong, I know the cutter is, the car is like singles?

I understand, I think your car is going well, do not worry. maaşallah