|
|
|
|
206 1.4 hdi errors and codes |
| • Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 206 | |
| 08.05.2020 20:09 | # 1 |
 h.can |
|
|
1- P0102 -mass or volume air flow circuit low input 2- P1113 -fuel pressure, below the limit value 3- P0704 - failure of the clutch switch input circuit My tool has given these errors, what should I do now according to these errors. When the vehicle starts for the first time, it makes a intermittent noise, as a wise sound gets warmer, the sound decreases and stops as soon as possible, the engine malfunction lamp lights up, sometimes it gets picked up, sometimes it clears in a few starts. Thank you in advance ... |
|
| 08.05.2020 20:09 | # 2 |
 Selox |
|
|
1-Take off the air flow meter, remove the residue from it with the lining spray and dry it. Then plug it in again. 2-Fuel pump may be faulty. I don't know about 3 for now. I guess that stopping is also related to the fuel pump. But first, what I said at 1 does not take too long. I guess this is a seriously recovering vehicle. Failure 2 can also be due to the mixture. maybe it can go when the fault at number 1 is gone. : D I mean good faith. |
|
| 08.05.2020 20:09 | # 3 |
| h.can |
|
|
Selox, first of all, thank you for writing an answer. Is it possible to find a visual about the plug and clean about it ... thanks ...
|
|
| 08.05.2020 20:09 | # 4 |
| Selox |
|
 That's right, so I suggested that you choose this path first. The part in the picture. easy to disassemble. After removing the plug of the hose, it is necessary to unscrew the screw with the socket. After that, the piece is already in your hand. It is sensitive, do not put any parts inside, only spray cleans with pressure. Then you plug it in. Can you report the result, what will happen next. |
|
| 08.05.2020 20:09 | # 5 |
| h.can |
|
|
thank you for the picture, is there any chance that these stops will be related to this ... I apply and report the result of course ... |
|
| 08.05.2020 20:09 | # 6 |
 sonerkyl |
|
|
stopping may also be caused by the diesel filter.
|
|
| 08.05.2020 20:09 | # 7 |
| h.can |
|
|
Thank you Soner ewet I will replace all filters, I will change oil ... Thank you ...
|
|
| 08.05.2020 20:09 | # 8 |
 KILIC |
|
|
delete errors first. Do not use anything other than lining spray while cleaning the flow meter, and also contact it by hand or sensor.
|
|
| 08.05.2020 20:09 | # 9 |
| h.can |
|
|
I will do as you say ok ... Thank you ... |
|
| 08.05.2020 20:09 | # 10 |
| h.can |
|
|
[QUOTE = h.can] Hello friends, the codes I get when I connect my car to the computer are as follows; 1- P0102 -mass or volume air flow circuit low input 2- P1113 -fuel pressure, below the limit value 3- P0704 - failure of the clutch switch input circuit My tool has given these errors, what should I do now according to these errors. When the vehicle starts for the first time, it makes a intermittent noise, as a wise sound gets warmer, the sound decreases and stops as soon as possible, the engine malfunction lamp lights up, sometimes it gets picked up, sometimes it clears in a few starts. Thank you in advance ... The maintenance of the vehicle was made. Original parts were used. The meter was cleaned. The sound of the vehicle and gas was noticeable. However, when the vehicle first started, it makes intermittent sound, the sound decreases as the sound of a wicked sound gets warmer ...
|
|
| 08.05.2020 20:09 | # 11 |
| Selox |
|
|
Did you also do Egr cleaning?
|
|
| 08.05.2020 20:09 | # 12 |
| h.can |
|
|
I did not clean the egr. If I could share an audio file in the comments, I could not upload the sound file but I could not load the audio file. The idle is normal when the car starts, but when the gas turns on, it makes a loud sound like 1000-2000 revolutions, except for the engine sound, and the engine stops when it goes over 3000 revolutions. I also tried this idle idle, when I run the gas when I see it, 3000 revolutions, the idle is broken and it stops immediately. Now what I'm going to do is confused. Thanks...
|
|
| 08.05.2020 20:09 | # 13 |
| Selox |
|
|
Brother, I tried to help as much as I can. I really wonder what the problem is. Be sure to write the solution here. Friends in Istanbul will help with the master. If there is a very difficult situation, go to the authorized service for 1 day, but the car will find the problem. It was 100 TL in Kayseri but I don't know what is in Istanbul. You don't have to get it done. It is also made according to another master. But they find the problem. |
|
| 08.05.2020 20:09 | # 14 |
| h.can |
|
|
[QUOTE = Selox] Brother, I tried to help as much as I can. I really wonder what the problem is. Be sure to write the solution here. Friends in Istanbul will help with the master. If there is a very difficult situation, go to the authorized service for 1 day, but the car will find the problem. It was 100 TL in Kayseri but I don't know what is in Istanbul. You don't have to get it done. It is also made according to another master. But they find the problem. [/ QUOTE] Thank you, my friend, you tried to be a great help.
|
|
| 08.05.2020 20:09 | # 15 |
 erkanengin |
|
|
Greetings the subject is quite old, but with the error code p1113, you found a solution. I have that same problem. the vehicle does not eat gas, stops and stops. ramp manager egr all changed but still not resolved
|
|