106 Quik headlight dimming

Friends, I wanted to share my little work with you. It is not entirely mine.

Materials

1) matte spray paint
2) orange glass paint
3) fine sandpaper
4) silicone
5) Blow dryer
6) paper tape

In the first stage, I used the blow dryer to remove the glass of the headlights, and when it warms the edges of the glass, the silicone releases itself, and can remove it by boiling water.



Then we make the signal reflector edge and the sides of the headlight glass ready for painting with fine sanding












After the masking and painting process is finished, we paint the signal glass with orange glass paint.





we can now silicon the glass as a finishing process




In these, I painted the parking bulb and the double lamp bulb (I used for the American park) signal bulb in orange, it was very nice ...



I am going to wear the headlights, friends, I will freeze until the weather turns off the cold bumper.

Well if we darkened my headlights :)

[QUOTE = kursat3006] Well, if we darkened my headlights as well:) [/ QUOTE]

Quick I also saw ten numbers on the bench, if my memory does not mislead me

nice work to your hand health, bye

But wouldn't they paint the bright part of the headlight dimming?

It has been a good expression, good health

I do not understand what is good health work, the rings of the right headlight are sometimes burning, sometimes it is not loosening :(

[QUOTE = kursat3006] [QUOTE = kursat3006] Well, if we darkened my headlights:) [/ QUOTE]

Quick I also saw ten numbers on the bench, if my memory does not mislead me [/ QUOTE]

yes brother you see it right i am working in ankamall some are just painting the signal part but i painted around the headlight glass it was not bad

[QUOTE = volkanC2] Good health to your hand, I don't understand what the right headlight rings are sometimes burning or sometimes not loosening :( [/ QUOTE]

If the sibling rings are original, it works with 2 leds. These leds are 3v, battery 12v. There is a circuit that reduces this voltage to 3v. It is malfunctioned.

As someone who likes to disassemble the car, I have a question :) To remove the headlights, it is necessary to remove the bumper, right? and is the bumper easy to remove?

Good health has been working.