Peugeot Forums - Peugeot Fan Club

106 Quik American parking + fender signal coupling

Homepage » PEUGEOT MODIFIED PLATFORM » 106
08.05.2020 18:29 # 1
Ahmet_ach
Hello everyone, let me tell you about the work I do today, I'm going to show you how to make an American park for 106 pictures.

Materials;
1) Car (106)
2) American parking module
3) Cable up to 2m at least 0.75mm
4) You can make it from 1 control pen or bulb
5) tape, side cut, kirko screwdriver etc ...

the construction phase

first of all we need to disassemble the wheel, it is very close to the ground, our hand does not fit in the hood
Let's lift the wheel and lift the wheel





Then there is the hood of the hood near the front signal, we open this cover and reach the front signals



Now, we pull 1 cable in the parking lights of the vehicle, grab it, there are gaps next to the headlight, we take it from the hood that we opened, and we pull it to the fender signals without cutting the cable and the cable we take from the parks will be (+).




we take the end (+) from the parks directly to the fender signal and find the end of the fender signal (-) and connect the end we receive from the parks to the (+) end of the fender signal, this tip is yellow green in most (-) pejoes.




so we connected the fender signal to the parks and it will work even when we signal but it will work in the opposite direction of the front and rear signal.


However, the main issue is that we extend the hand from the hood cover we remove and turn the front signal sense by removing the front (+) and (-) ends, we find it with the control pen or the lamp bulb we made our own, we find the (+) end of the signals, if there is a double plus cable, if there is a double color cable, it is definite. We find (-) and we disconnect the (+) end from the signal and cut it off from the signal, we connect the end coming to the main signal to the blue end color of the module, we connect the signal cable we cut from the module to the signal end that outputs from the module, that is, the green color. we connect the color red
(The ads belong to the module I use may differ in other modules)













and our american park is ready






















08.05.2020 18:29 # 2
Guests
Bless your hands.
08.05.2020 18:29 # 3
kuscu38
a kind of work that most of us would like to deal with. Thanks for information...
08.05.2020 18:29 # 4
ALLEX
2-year ghosting

While searching for the subject came across.
This evening, there is a transparency application
08.05.2020 18:29 # 5
serdaralisan
I have a health teacher, but I hate the American parking system. It cost 800 TL. When I bought megane 1 coupe 106, the American was different when I bought the car. 200 TL American Park Module is crushed as a result of the crash and burned the whole installation. 800 TL Installation is making a hole next to the most beautiful signal and putting a small parking bulb so that it lights up like an American parking bulb, and because the signal bulb is big, it gives its light when it sounds like an American park. )
Peugeot Forums - Peugeot Fan Club © 2024
“The most auspicious of people, it is people who are useful.”