106 QS Non-Extinguishing Airbag, Non-Flammable Signal Repair

Problem: The Airbag warning lamp of our 2000 Model 106 Quik silver vehicle is constantly blinking, the signal indicator lamps do not work. The signal indicators were burning once in a while. This is our image. No signals, airbag flashing. It appears when you pull the indicator hands towards you without pushing it too hard. Very sensitive extreme attention alone !!! Here is the disassembled circuit behind the panel. This is the view from the inside of the socket pins that are problematic. Some pins soldered. This is the hand brake, signal, oil, overheat etc. that the socket passes (front side) is yellow. the indicator lights, the black socket belongs to km, rev, petrol indicators, km meter and backlights. The solder feet are soldered again. Soldering requires a lot of attention. Because soldering or overflowing increases the possibility of making chassis on the panel. You can lose the indicators completely !!! And the result is: Our signal indicators are working. The airbag light returns to normal. Note: Not a quote. handcraft eye gravis_pro2011-11-08 20:16:54

hey maşallah hey maşallah :) health in your hands & nbsp;

Health to your labor ...

Thank you too ... gravis_pro 2011-11-09 20:07:02

I made a long and long trial today. No problem, thank goodness ...

Very useful sharing, brother, health is on their hands, the indicator lights are very vivid, do you have an operation on it? :))

[QUOTE = I Love My Pug] A very useful sharing bro, his hands are very lively in the indicator lights, do you have an operation? :)) [/ QUOTE]

Nice share. Thanks. Your oil lamp is also lit only? & Nbsp; & nbsp; Does it normally light while running? I have not seen it burned until now. Alicangulpinar 2011-11-09 20:21:16

[QUOTE = Alicangulpinar] Good sharing. Thanks. Your oil lamp is also lit only? & Nbsp; & nbsp; [/ QUOTE] < div> & nbsp;

When the ignition is switched on, it should go out when it starts. If it is not lit there is a problem.

Mine doesn't burn when I turn on the ignition. I'll show him when I go to 10,000 maintenance. Why do you think he can?

Smd leds do not break easily. Maybe the solder of the socket has blown like me or it goes to the oil sender I had some of the 26 ends of the socket broken. gravis_pro 2011-11-09 20:41:44

Thank you & nbsp;

[QUOTE = Alicangulpinar] Thank you & nbsp; [/ QUOTE] < div> You're welcome. But you don't know about negligence ...

Of course, & nbsp; & nbsp; I check my oil myself, I don't think there will be a problem until I leave.

[QUOTE = Alicangulpinar] Sure & nbsp; & nbsp; I check myself myself, I don't think there is a problem often, until I leave [/ QUOTE]

Does the oil pressure drop before the oil decreases?

If the oil pump does not work, it cannot carry the oil in the crankcase to the engine. I do not know much technically, I would not say wrong.

I couldn't think of that. It makes sense. I hope I will get it done as soon as possible. thank you again for your interest.

[QUOTE = Alicangulpinar] I couldn't think of that. It makes sense. I hope I will get it done as soon as possible. Thank you again for your interest. [/ QUOTE]