Peugeot Forums - Peugeot Fan Club

106 QS HEATER DOES NOT HEAT

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 106
08.05.2020 16:22 # 1
AG930
Hi friends ... & nbsp; I have 106 quiksilver 2000 models .... I have a problem in the heating system of the vehicle can not warm up :)
engine hot & nbsp; opens thermostad & nbsp; I also work in the circulation but I cut it out inside the vehicle :(
The first & nbsp; heater core that comes to my mind is that.
08.05.2020 16:22 # 2
kaderim@61
the non-heating chiller gasket was burning and it happened to me
08.05.2020 16:22 # 3
AG930
A motor master said he can do it from the gasket, he takes the air from the gasket.
what else does it have to do & nbsp; you do not overheat the car, it says the gasket is not burned
but the water does not mix the oil does not reduce the oil & nbsp; The engine is not overheating. The engine is running smoothly.
I don't understand.
08.05.2020 16:22 # 4
kaderim@61
Normally the heated water needs to blow the inside of the heating radiator when the fan is on, the motor of the heater is running or you have paid attention to the cold hot separator latch
08.05.2020 16:22 # 5
koliva
If the heater core is obstructed, why would the vehicle heat up?
Are the pipes to the heater core hot?
08.05.2020 16:22 # 6
psychoabi
check your water lack of water can cause the same problem
08.05.2020 16:22 # 7
Ucyuzalti
Moisture-free honeycomb plugged

08.05.2020 16:22 # 8
Guests
I think you control your heating button, even if the button is stripped from the back and turns from the front, it does not rotate from the back, it is a bit softer than the old one.
08.05.2020 16:22 # 9
mehmetaydinpug
I had the same problem, I bought the vehicle in the summer, the winter came, I opened the bodywork, it was working, but it was blowing cold, the heat exchanger was broken, they removed the hose, right after the engine, two pipes must be entered right behind the engine.
08.05.2020 16:22 # 10
Ucyuzalti
The level key of my boiler was working & nbsp; I have the resistive button connected, there is an automatic resistance working in the 4th level & nbsp; so in my 306 :))
08.05.2020 16:22 # 11
AG930
yes friends, i left the car for repair ... waleo brand & nbsp; I bought the heater core ... I asked a few more masters if the heater core is blocked, the vehicle has no interest in fever. let the water heater pass through;) let the water pass through the end of the air, and the air was passing at the rate of 5%. ohhh like mis & nbsp; the weather is passing & nbsp; tomorrow the incident could not be trained to this day. With great chances, the heater was in honeycomb, but if you don't, then other places will hurt our heads: (& nbsp; money spent!)
08.05.2020 16:22 # 12
Ucyuzalti
How much did you buy the heater core?

08.05.2020 16:22 # 13
AG930
WALEO BRAND 90 TL
ELITCAR DIYE TRAJTAN BISEY VAR & nbsp; 45-50 TL

BUT THE WORKING IS A VERY CONVENIENT SITUATION (COMPLETE TORPEDO CONSOLE IS REMOVED) I HAVE RECEIVED THE WALEO.
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”