Peugeot Forums - Peugeot Fan Club

106 gti/saxo vts restoration

Homepage » PEUGEOT MODELS (FAULTS AND SOLUTIONS) » 106
20.02.2024 21:13 # 1
Berkay Erdinc
Hello everyone, we are aiming to rebuild our recently purchased car, which is quite disheartened, and strengthen its engine. I am leaving the link for those who want to follow. If you have any questions or suggestions, you can write here. https://youtu.be/poDyHewHm6w?si=dlAsjkwaBje-zv6z
29.02.2024 22:31 # 2
CanK_106
Good luck, I hope everything goes well. I'm eagerly awaiting the results, I'll be following :) By the way, I think speedline or compomotive would suit the rims. CanK_1062024-02-29 22:31:31
08.03.2024 16:59 # 3
Berkay Erdinc
[QUOTE=CanK_106]Good luck, I wish you all the best. I'm looking forward to the result, I'll be following :) By the way, I think the rims would suit a speedline or a compomotive. [/QUOTE] Thank you very much. Right now, we have supplied the fuel pump, regulator, e85 injectors, pt52 camshafts and I ordered the 12.5 compression ratio forget pistons. There are no extra parts left except the standole ecu, r8 coils and headers. Since the other parts I will buy will be the car's parts, I think I'm over the troublesome part. I'm planning to completely reduce the torsion bar in the next part. There will be a part about the torsion bar problem and how it works, I'll see if there are any surprises, I'm progressing slowly. Thank you again Berkay Erdinç2024-07-28 16:26:40
Peugeot Forums - Peugeot Fan Club © 2025
“The most auspicious of people, it is people who are useful.”