106 bumper removal + headlight replacement

Hello friends, I will share with you the change of headlights I made recently, and the production is entirely my own.


Ingredients;
1) kirko
2) 10mm open mouth ratchet wrench
3) 10mm socket
4) dexterity (most important)

In fact, a simple but difficult job is available, there are 4 pieces of 10 nuts in total, two of which are close to the fenders, the other two appear under the bumper when the car is under the car.
Anyway, the building stage is as follows, we lift the car with a cuff



we can unscrew the nut just above the right fender hood with a 10mm ratchet wrench.



Then, when viewed from the bottom, there is a nut between the hoses going to the radiator, and we remove it with a 10 mm socket.






so we have removed the nuts on the right side. After doing the same operation on the left side, we pull the bumper towards us and the bumper is removed.








We will use the socket to remove the headlamps.



Since I got bored with angel headlights, I put on the headlights that I had darkened by myself.






Ahmet_ach 2014-11-28 21:04:50

In this way, it looked really good, even better than angel headlight, I think these are not exactly decided, but in summary two kinds are nice :)

Original candir :)

[QUOTE = yawruaslan] Original candir :) health to your hand [/ QUOTE]

I just bought a lot of trinkets, my first priority will be to turn it back to original and then start modifying, otherwise there are always hardships as there is no hard workmanship.

I wonder if the subject was 3 years ago

the subject is old but you can make the information sound.